Amendment_0001_to_PD08WRGBGBEB16B_-_12_Dec_2013.pdf

Amendment 0001 to PD08WRGBGBEB16B 12 December 2013

1. Page 6, para 3.3.2, Markings, third sentence, delete, “, but shall not be less than ½-inch high”.

2. Page 4, para 3.3.1.2, Protective coating, add to the end of the last sentence, “after assembly”.

3. Page 9, para 3.4.3.3, Ice, delete the second sentence.

4. Page 10, Table II, last row, change the requirement to read, “Minimum turning radius (feet)”.

5. Page 11, para 3.6.4.3, Minimum curb-to-curb turning radius, delete, “curb-to-curb” from both the paragraph title and the paragraph itself.

6. Page 11, para 3.7.1, Tires and wheels, first sentence, change “Tire and Wheel Association” to “Tire and Rim Association”. Add to the end of the last sentence, “; the wheels may be manually disconnected from the steering linkage for side movement.”

7. Page 12, para 3.7.8, Fenders, change the paragraph to read, “Fenders are not required.”

8. Page 12, para 3.7.9, Mudflaps, change the paragraph to read, “Mudflaps are not required.”

9. Page 13, para 3.9, Rails, fifth sentence, delete “Figure 2” and replace with “Figure 6”.

10. Page 14, para 3.9.1, Adjustments, change the sentence to read, “The rails shall be joined together to obtain the following minimum adjustments as shown in Figure 2 through Figure 5 below at any height as shown in Table II (with and without spacers) and with any load from no load and the proof load:”

11. Page 21, Table III, Requirement verification matrix, delete “curb-to-curb” from “3.6.4.3, Minimum curb-to-curb turning radius.” For the entries for 3.7.8, Fenders, and 3.7.9, Mudflaps, change the “Verification Method” and the “Section 4 Verification” column entries to read, “N/A”.