RFI 3.docx

Requests for Information #3

QUESTION #1

The Tennsco model # used in this solicitation (TNNSTS1218723SD) is for a group of three lockers. So, with a quantity of 160 ea., this would be a total of 480 lockers. Yet, there are only 160 sloping tops and 160 front bases specified. Are you looking for 160 lockers or 480 lockers? Then, there are 160 end bases specified. End bases are only used on the end of each run, so for instance if there were 10 lockers in a run, you would need two end bases for each run of 10.

Could you please clarify for me the quantity of lockers, tops, front bases and end bases needed for this project?

RESPONSE #1

The quantity required is a total of 160 single lockers. Additionally, the total quantity of End Bases (CLIN0003) has been reduced by 120, from 160 to 40 per Modification/Amendment dated 22 August 2012.

QUESTION #2

Will these lockers go back to back, side to side? Could you provide a rough drawing of the room(s) where they will be installed and indicate locker location please.

These lockers come in 3 wide set-up, is this acceptable or do you want them all to be single? This really depends on the floor plan for these lockers.

Will these be installed on a first floor or upper level?, if so, what level and how may we transport them up, elevator or stair carry?

RESPONSE #2

The lockers will be single style, side-by-side, all on the first floor in a secondary hallway and along a fence in the back warehouse. A drawing of the room and layout has been attached to the solicitation under Drawings #1.

QUESTION #3

We have a question about the quantity of lockers required for FA 46642228A001. The Tennsco part number in the solicitation is for a 3-wide locker assembly. The question is, does March AFB want (160) 3-wide assemblies for a total of 480 lockers or is the requirement for a total of 160 1-wide lockers?

RESPONSE #3

See response #1