Statement_of_Work_-_Global_Hawk_Protective_Covers.pdf

STATEMENT OF WORK

Intake Plug with Ram Air Duct Plug, Exhaust Plug, & Pitot Static Tube Cover for Global

Hawk Aircraft

69 MXS GLOBAL HAWK

GRAND FORKS AIR FORCE BASE

1. GENERAL: These protective covers, mandated by Technical Order RQ4-B-10-10-00-00A-

018A-A paragraph 1.2, are used to prevent entry of foreign matter into aircraft intakes, exhaust, and pitot static tubes.

2. REQUIREMENTS AND DETAILS:

a. All covers must be made with heavy-duty vinyl material. The Pitot Static Tube Covers should be able to withstand a temperature of 200 degrees farenheit.

b. The covers need to have “Remove Before Flight” streamers installed on them and should be removable from the intake/exhaust covers. The Pitot Static Tube covers should have the remove from flight streamer sewn in to the seam be approximately 23.5” in length.

Each streamer on the intake and exhaust plug should be approximately 14 inches in length. See attached pictures for references.

c. Covers need to be made in the color of Royal Blue or similar (color sample to be provided for approval).

d. Velcro patches are required to be sewn on each intake, exhaust, and pitot covers with removable embroidered tail number patches. A total of 13 different tail number sets will need to be included. The Velcro for the intake plug should be approximately 12” in length and the exhaust plug Velcro should be approximately 10” in length and be 2 to 3” in height for each. The Velcro for the Pitot Static Tube covers should approximately 3” in length and 1” in height. The patches for the Intake and Exhaust covers should be installed horizontally two to three inches underneath the squadron patch on the front side of the covers. The patches for the Pitot Static Tube covers should be installed horizontally near the base of the cover. See attached pictures for reference.

e. Each Intake Plug shall have a Ram Air Duct Plug. The Ram Air Duct Plug shall include a 13 inch removable strap that should be installed on the bottom of the Intake cover. The ram air duct should be approximately 10” wide by 3” height and 6.5” deep. See attached pictures for reference.

f. Each intake/exhaust cover should include two handles on the front of each cover and should be installed approximately 10” from the widest part of the intake cover and 6” from the widest part of the exhaust cover and be 10” in length. See attached pictures for reference.

g. Each intake intake/exhaust cover should include our squadron patch that will be sewn, centered, on the front of each cover. The patch on the intake cover should be approximately 19” by 17” and the patch for the exhaust cover should be 13” by 12”. See attached pictures for reference.

h. The intake cover outside lip should be approximately 30” at the base, and 50” at the widest part in the middle and 39” in height. The inside of the intake plug should be approximately 25” at the base, 43” at the widest part in the middle, 33” in height and should be 7” deep on the bottom and 5” deep on the top. See attached pictures for reference.

i. The exhaust cover outside lip should be approximately 30.5” at the base, 32” at the widest part in the middle and 33.5” in height. The inside of the exhaust plug should be approximately 28” circle and 6” deep. See attached pictures for reference.

j. The Pitot Static Tube cover should be approximately 18.25” in length, 3.25” wide at the base and 1” at the tip. See attached pictures for reference.