The file's text, extracted by GovTribe without its formatting.
APPENDIX D
Minimum Acceptable Services for Monthly PM&I
DUMBWAITER [ELEC / HYD]
Check with Facility Manager for any problems Operate dumbwaiter through complete cycle & check operation for unusual noises or problems Check operation of emergency lights and alarm Inspect, clean and lubricate motor Inspect pump and valve unit for leaks [Hydraulic] Inspect tank oil level ; add as required [Hydraulic] Inspect jack seals [Hydraulic] Check operation of indicator lights and buttons Inspect and lubricate rails and guides Fill out maintenance checklist and report deficiencies
HANDICAP WHEEL CHAIR LIFT
Check with Facility Manager for any problems Check bolts securing drive cabinet and base, tighten as needed Check belt tensions Check cam rollers Check wear pads for excessive wear Inspect & lubricate upper and lower bearings Check fastening and cable harness Check alignment of platform and doors Check door interlock switch for proper operation Check operation of final limit switch, emergency stop / alarm Check call/ send controls at each station and on platform Lube hinge of flip up ramp and wherever else needed
LOADING DOCK HYDRAULIC LIFT
Check with Facility Manager for any problems Check for proper operation of pump Check for leaks on piping, seals, packing gland, suction & discharge Check pump and motor operation for excessive vibration, noise and overheating Check alignment of pump & motor, adjust as necessary Lubricate pump and motor
ELEVATOR, HYDRAULIC [PASS/FREIGHT]
Check with Facility Manager for any problems Ride car, checking for any unusual noise, vibration or operation Inside the Car, inspect and clean fixtures & signals in the operating panel, car position & direction indicator Check operation of the emergency lights and bell Check handrails, ceiling panels and hang on panels for tightness Check for tripping hazards Inspect and lubricate rails of hoistway Hallway corridor: inspect hall buttons, signal lamps, lanterns and hall position indicators Inspect starter station, key operation and lamps MOTOR ROOM: Inspect machine room equipment Lock out and log record Inspect tank oil level Inspect and adjust controller contacts; main operating contactors and switches Inspect pump and valve unit for leaks Inspect/clean/lubricate cab top guides, steading devices, safety switches, inductors, leveling devices, selector tape, switches, hitches and fan motor Inspect/clean/lubricate door operator roller tracks, upthrusts, related cables, clutch, retiring cam and door gib Inspect door operator, clean and lubricate chain and belt tension.
Inspect door, clean and adjust safety edge, light ray and cables Clean and adjust proximity devices on door Clean equipment and surrounding area
ELEVATOR, ELECTRIC /TRACTION [PASS/FREIGHT]
| 1 |
| Check with Facility Manager for any problems |
| 2 |
| Ride car, checking for any unusual noise, vibration or operation |
| 3 |
| MOTOR ROOM, visually inspect controllers, starters & selector |
| 4 |
| Lubricate and adjust tension on the selector |
| 5 |
| Inspect sleeve bearings of hoist motor, exciter and motor generator |
| 6 |
| Inspect brushes & commutator of hoist motor, exciter & motor generator |
| 7 |
| Inspect sleeve bearings of regulator dampening motor & tach generator |
| 8 |
| Inspect brushes& commutator of regulator damp mtr & tach generator |
| 9 |
| Inspect and grease sleeve bearings of geared machines |
| 10 |
| Inspect oil level in worm and gear of geared machines |
| 11 |
| Visually inspect the brakes |
| 12 |
| Visually inspect cables, chains, hoist, compensating governor for wear & equalization |
| 13 |
| Clean and lubricate brakes, pins and linkage |
| 14 |
| Hatch: Lubricate rails of hoistway |
| 15 |
| Inspect car top & grease sleeve bearings if needed |
| 16 |
| Inspect counterweight, chains, hoist and compensating governor if necessary |
| 17 |
| Inspect door operator, clean & lubricate chain and belt tension |
| 18 |
| Lubricate cables, chain hoist and compensating governor |
| 19 |
| Clean and adjust proximity devices on doors |
| 20 |
| Inspect & clean fixtures and signal in operating panel, car position & direction indicator |
| 21 |
| Check operation of emergency lights and bells |
| 22 |
| Check handrails, ceiling panels and hang on panels for tightness |
| 23 |
| Check for tripping hazards |
| 24 |
| Inspect hall buttons, signal lamps, lanterns & hall positions indicators |
| 25 |
| Inspect starter station, key operation and lamps in hallway |
| 26 |
| Clean equipment and work area |
| 27 |
| Fill out maintenance checklist and report deficiencies |
FA2860-15-R-0007
Attachment 5