A06_Specifications.pdf

REQUIRED SPECIFICATIONS OF

Amphibious Track Vehicle with Trailer

BODY:

Approximate Dimensions: 15’6” - 17’ Long x 8’- 9’ Wide x 8’ - 8’8”High

Welded 1/8” and 3/16” Aluminum Body

6900 - 8000 LB (approx.)

Minimum 1300 lb. Floating Load Capacity

Walking deck full width of the tracks with slip resistant deck surface.

Minimum 28” Ground Clearance

Easily accessible and serviceable Fuel Tank

Overhead cargo rack capable of supporting 100 lbs.

(2) plugs installed in the body for drain purpose

CAB:

Seating for 2 people

Overhead Rack/Brush guard

Minimum required gauges:

o Tachometer o Engine Oil Pressure o Engine Temperature o Hydraulic Temperature o Battery indicator / Voltmeter o Hour meter o Water level indicator for fire suppression package.

Winch Control or remote plug located in cab

Actuator for pump (fire suppression package) located in cab

Drive controls operational from either seat.

2 rear view mirrors (round fisheye style preferred) or single large panorama style mirror is acceptable

DRIVE SYSTEM:

70 - 115 HP Diesel Engine

TIER 4 FINAL CERTIFIED MEETING ALL

REQUIREMENTS SET FORTH BY THE EPA

FOR 2019 OFF ROAD DIESEL ENGINES

Twin Hydrostatic Transmission

SPEED:

6-8 mph on land, 1 mph in water

TRACK SYSTEM:

Aluminum Cleats

Low Stretch Rubber Track Belts

Corrosion-resistant / stainless-steel track bolts and hardware for saltwater usage.

Bolt on bogey wheel design for easy replacement.

Front idler shafts and rear drive shafts to be stainless s steal

Approximately 1 psi ground pressure

ELECTRICAL SYSTEM:

12 Volt Battery Secured in Enclosed Compartment

2 LED Front Lights/2 LED Rear Lights

12 Volt Auxiliary Receptacle in cab

WINCH & JACK:

Front Mounted Winch rated to pull a minimum of the total maximum rated weight of machine.

Minimum 75’ of wire rope on winch

Weight rated jack to lift the machine

FIRE SUPPRESSION PACKAGE

90-120 gallon minimum poly water tank located in the bed

Water Level Gauge for Tank (Mounted in cab)

Hydraulic Motor Driven, Self-priming Centrifugal Water Pump

15’ of 1 ½” Suction Hose for quick fill from ditch or lake

Minimum 2 lifting attachment points on tank for removal / servicing.

TRAILER SPECIFICATIONS:

Tilt deck trailer with raised center to prevent slide off while loading and unloading.

(2) 7000 lb axles

Machine access ladder: mounted for easy access to machine while loaded on trailer

Matching spare tire and rim, mounted on trailer electric brakes

Electric brake actuator with breakaway

2 5/16” forged adjustable coupler

Minimum GVWR of 13,000 lbs.

Tongue jack sufficiently strong to allow trailer to be disconnected with fully loaded machine left on it.

Manual tilt with hydraulic cylinder dampener

Four (4) D-ring tie downs

2 galvanized safety chains per DOT specs

Light package with (4) LED stop/tail, (4) 2” amber clearance lights and (7) red clearance lights

Reflector package with (4) 2” red and (2) 2” amber and reflective tape side and rear per DOT standards

7 bladed light connector

4 tie down straps weight rated for the machine to secure machine to the trailer