36C77018R9601-0003006.pdf

Tucson CMOP SAVAHCS Storage Mezzanine Tucson, AZ

SECTION 10 26 00

WALL AND DOOR PROTECTION

PART 1 - GENERAL

1.1 DESCRIPTION:

A. This section specifies corner guards.

1.2 SUBMITTALS:

A. Submit in accordance with Section 01 33 23, SHOP DRAWINGS, PRODUCT

DATA, AND SAMPLES.

B. Manufacturer's Literature and Data:

1. Corner Guards.

C. Samples: For each exposed product and for each color and texture specified, 12 inches (300 mm) long.

1.3 DELIVERY AND STORAGE:

A. Deliver materials to the site in original sealed packages or containers marked with the name and brand, or trademark of the manufacturer.

B. Protect from damage from handling and construction operations before, during and after installation.

C. Store in a dry environment of approximately 21 degrees C (70 degrees F) for at least 48 hours prior to installation.

1.4 WARRANTY:

B. Manufacturer Warranty: Manufacturer shall warranty their wall and door protection for a minimum of five (5) years from date of installation and final acceptance by the Government. Submit manufacturer warranty.

1.5 APPLICABLE PUBLICATIONS:

A. Publications listed below form a part of this specification to extent referenced. Publications are referenced in text by basic designation only.

B. ASTM International (ASTM):

A240/A240M-14...........Chromium and Chromium-Nickel Stainless Steel

Plate, Sheet, and Strip for Pressure Vessels and For General Applications

C. The National Association of Architectural Metal Manufacturers (NAAMM):

AMP 500-06..............Metal Finishes Manual

PART 2 - PRODUCTS

2.1 CORNER GUARDS:

A. Surface-Mounted, Metal Corner Guards: Fabricated as one piece from formed metal with formed edges; with 90-degree turn to match wall condition.

10 26 00 - 1

Tucson CMOP SAVAHCS Storage Mezzanine Tucson, AZ

1. Material: Stainless-steel sheet, Type 304.

a. Thickness: Minimum 16 gauge.

b. Finish: Directional satin, No. 4.

2. Wing Size: Nominal 1 by 1 inch.

3. Height: 48 inches.

4. Mounting: Double-stick tape.

PART 3 - EXECUTION

3.1 INSTALLATION

A. General: Install corner guards level, plumb, and true to line without distortions. Do not use materials with chips, cracks, voids, stains, or other defects that might be visible in the finished Work.

1. Install corner guards in locations and at mounting heights indicated on Drawings.

B. Remove excess adhesive using methods and materials recommended in writing by manufacturer.

C. Where corner guards are installed on exposed structural glazed facing tile units or masonry wall, partitions or columns, // anchor corner guards as shown on the construction documents // // anchor corner guards to existing walls with 6.35 mm (1/4-inch) oval head stainless steel countersunk expansion or toggle bolts // // anchor corner guards with four nominal 1.37 mm (0.0516-inch) thick, adjustable galvanized steel anchors, spaced as shown on construction documents. // Grout spaces solid between guards and backing with Portland cement and sand mortar.

- - - E N D - - -

10 26 00 - 2