1-Statement_of_Work.pdf

Rocky Mountain Laboratories requires replacement of the ash removal system for the facility incinerator.

Quotes for this work should include all costs related to removal of the existing conveyor and disposal of parts, installing catwalk support beam, installing hydraulic lift platform, modifying existing ash chute, and modifying the hand rails to increase safety based on OSHA requirements.

Specifics to include:

1. Removal and disposal of existing ash conveyor.

- Ash conveyor located within the incinerator pit must be disassembled and disposed of to allow for installation of new lift system within the north end of the pit (see picture).

2. Installation of beam to support existing catwalk over the pit.

- Existing catwalk is currently supported by the ash conveyor (see picture).

- Support post and beam must be installed so that catwalk can remain in this location.

3. Installation of hydraulic lift platform within the north end of pit to be used to lift ash waste container out of pit.

- Hydraulic platform lift must have base dimensions of 50” x 50” to accommodate ash waste container.

- All necessary hydraulic cylinders, power units, electric controls, hoses and fittings to be installed.

- Materials must be appropriate for use in wet environments, i.e. powder coated steel and stainless-steel hoses where required.

4. Modification of incinerator ash chute to facilitate efficient transfer of ash from incinerator to waste container.

- Incinerator ash chute must be narrowed to facilitate transfer of incinerator ash to waste container (see picture)

5. Modification of guard rails on north end of pit to allow for transfer of ash waste container from hydraulic lift platform to ground surface.

- Removable guard rail system must be installed according to OSHA requirements.