Steel Gear Lockers

Requires 80 Ventilated Steel Gear Lockers (Black or Dark Grey) to be used at the MFF school in Yuma, Arizona. See SF 1449 - H9223920Q0037 for details.

Vendors are encouraged to contact the Government for clarification if there are, or appear to be errors, omissions, or inaccuracies in the RFQ. Questions shall be submitted to SFC Yang, Ye at 910-432-8697 or ye.yang.mil@socom.mil. Questions are due NLT September 2, 2020, 0400 PM, EST.

                                                     Characteristics:

1) At least 72" Tall, 36" Wide, and 24" Deep but not greater than 84" Tall, 40" Wide, and 40" Deep.

2) Made of 16 gauge or better steel.

3) Ventilated sides and ventilated double doors that open in the center of the locker.

4) The locker must be divided into several partitions with the following characteristics:

5) The lockers must have the ability to hang a student jumpsuit (a one-piece, adult sized garment) without folding the jumpsuit.  Minimal folding at the bottom of the suit is acceptable, but needing to fold the jumpsuit in half is unacceptable.

6) The floor of the locker in the area where the Jumpsuit is hanging must be able to support a 70lb rucksack.

7) There must be two partitions at least 28" Tall x 18" Wide x 20" Deep.  Both must be able to support a 45lb Packed RA-1 Parachute System. MFFS recommends stacking these two partitions and placing them beside the partition for the rucksack and jumpsuit, but is open to other formats.

8) There must be another partition to hold Ops Core Bump Helmets, Communications gear, and personal effects.  This area must be at least 12" Tall x 18" Wide x 18" Deep, but not more than 18" Tall, 40" wide, and 40" deep.  MFFS recommends putting this partition above the other partitions, but is open to other formats.

9) The color must be Black or Dark Grey.