CBRN Survey Trailer

Added: Aug 17, 2016 11:36 am 6TH CST Survey Trailer
Scope of Work
NOTE:
ROAD SIDE = DRIVERS SIDE
CURB SIDE = PASSENGER SIDE
1. 8.5' X 24' ENCLOSED TRAILER. INTERIOR SHALL BE 24' (BEHIND V‐NOSE) X 8' W X 7' 4" T. REAR OF
TRAILER BODY SHALL INCLUDE REVERSE BEAVER TAIL FOR ADDED GROUND CLEARANCE
2. SHALL INCLUDE 4' DEEP V‐NOSE. V‐NOSE SHALL HOUSE GENERATOR ON ROAD SIDE. ABOVE
GENERATOR SHALL BE FULL WIDTH SHELF AND SHALL INCLUDE (2) SPARE TIRE MOUNTS WITH TIRES
MATCHING SPECIFICAITONS IN #35. THE CURB SIDE OPPOSITE THE GENERATOR SHALL HAVE A 48" WIDE
DOOR FOR ACCESS TO THE STORAGE AREA BEHIND THE GENERATOR. THIS AREA WILL NOT HAVE A
SHELF
3. THE V‐NOSE SHALL BE ISOLATED FROM THE INTERIOR BY A FULL WIDTH WALL WITH NO DOOR
4. GENERATOR SHALL BE A 7,000W GAS UNIT. GENERATOR PACKAGE SHALL INCLUDE SOUND
ATTENTUATED ENCLOSURE WITH VENTED DOOR, 18 GALLON BELOW FLOOR FUEL CELL, C02 DETECTOR
AND REMOTE CONTROLS. (CAMCO GENTURI CAN BE USED IF GENERATOR EXHAUST EXTENSION IS AN
ISSUE)
5. FULL WIDTH EXTRA HEAVY DUTY RAMP DOOR
6. INTERIOR FLOOR (TO INCLUDE INTERIOR OF RAMP DOOR) SHALL BE SPRAY IN NON‐SLIP BED LINER
7. SHALL INCLUDE (2) FULL LENGTH (INTERIOR MINUS V‐NOSE) RUNS OF RECESSED FLOOR MOUNTED ETRACK
AND (1) RUN OF RECESSED ROAD SIDE WALL MOUNTED E‐TRACK (APPROX 12" DOWN FROM
CEILING)
8. CEILING AND WALLS SHALL BE INSULATED WITH POLYSTYRENE INSULATION
9. CEILING SHALL BE FINISHED WITH WHITE VINYL CLAD PANELS
10. WALLS SHALL BE FINISHED WITH DIAMOND ICE COLOR ALUMINUM. THESE WALLS ARE DRY ERASE
CAPABLE. ALUMINUM IS INSTALLED OVER 3/8" PLYWOOD
11. SHALL INCLUDE (4) RECESSED FLOOR MOUNT 5K RATED D‐RINGS. RING PLACEMENT WILL BE IN
REAR 2/3 OF TRAILER IN A RECTANGULAR PATTER (NOT RUNNING ON CENTER DOWN THE LENGTH OF
THE TRAILER)
12. SHALL INCLUDE (2) 13.5K ROOF MOUNT A/C UNIT WITH HEAT OPTION
13. SHALL INCLUDE (1) 14 X 14 NON POWERED ROOF VENT
14. SHALL INCLUDE (1) 30 X 15 TINTED SLIDING WINDOW WITH SCREEN ON ROAD SIDE OF TRAILER
15. SHALL INCLUDE A 5' CURB SIDE COUNTER AND AN 8' FRONT MOUNT COUNTER. 8' FRONT COUNTER
SHALL BE PERMANENTLY AFFIXED AND 5' CURB SIDE COUNTER SHALL BE FOLD DOWN
16. SHALL INCLUDE AN ELECTRIC TONGUE JACK WITH NIGHT LIGHT AND BATTERY. BATTERY WILL
CHARGE WHEN CONNECTED TO THE VEHICLE
17. SHALL INCLUDE A 50A BREAKER PANEL
18. SHALL INCLUDE A 120V 8' POWER STRIP RUNNING THE LENGTH OF THE 8' PERMANENTLY AFFIXED
COUNTER WITH NO LESS THAN 8 PLUG OUTLETS
19. SHALL INCLUDE (12) INTERIOR 120V DUPLEX OUTLETS EVENLY DISTRIBUTED BETWEEN ROAD SIDE
AND CURB SIDE
20. SHALL INCLUDE LED INTERIOR LIGHTING RUNNING BOTH ROAD SIDE AND CURB SIDE LENGTHS
21. SHALL INCLUDE (2) REAR STABILIZER JACKS 5K CAPACITY
22. SHALL INCLUDE AN 18' ROLL OUT AWNING ON ROAD SIDE OF TRAILER
23. SHALL INCLUDE (2) 36" W X 78" T RV DOORS, WINDOW, DEAD BOLT AND KEY LOCK, ONE EACH ON
ROAD SIDE AND CURB SIDE. ALL LOCKS WILL BE KEYED THE SAME IN ORDER FOR 1 KEY TO OPEN ALL
LOCKS. DOORS SHALL INCLUDE RETRACTABLE STEPS
24. EXTERIOR COLOR SHALL BE INDIGO BLUE
25. OVERHEAD CABINETS SHALL BE ACROSS THE FRONT AND DOWN CURB SIDE (TO THE REAR OF CURB
SIDE DOOR) CABINETS SHALL BE OF WELDED ALUMINUM CONSTRUCTION CLAD WITH WHITE
ALUMINUM SHEETING WHICH IS ALSO DRY ERASE CAPABLE. CABINET DIMENSIONS SHALL BE 15" D X
15" T. CABINET HARDWARE SHALL INCLUDE LOCKING MECHANISM
26. SHALL INCLUDE (2) EXTERIOR 120V GFI OUTLETS
27. SHALL INCLUDE (2) WELDED STEEL PLATES BEHIND WALL FOR SCBA CASCADE BRACKETS IN CURB
SIDE V‐NOSE COMPARTMENT
28. SHALL INCLUDE (1) FOLDING SOFA 72" LONG. SOFA FOLDS AGAINST ROAD SIDE WALLTO STOW
29. SHALL INCLUDE (6) RED/BLUE 12V STROBES. (4) STROBES WILL BE LOCATED AT THE TOP CORNERS
OF TRAILER (2 EACH ON ROAD AND CURB SIDE) AND (2) STROBES WILL BE LOCATED ON THE REAR
ABOVE THE TRAILER DOOR. STROBES SHALL BE WIRED TO THE TONGUE WITH A STUB WIRE. WIRE SHALL
BE OF SUFFICIENT LENGTH TO ALLOW END USER TO INSTALL ELECTRICAL PLUG AND REACH BUMPER OF
PRIME MOVER
30. SHALL INCLUDE (4) FLUSH MOUNTED EXTERIOR SCENE LIGHTS (1 PER CORNER ON ROAD AND CURB
SIDE)
31. SHALL INCLUDE (1) WEATHERPROOF CABLE ACCESS DOOR (APPROX 6" X 6") ON THE CURB SIDE
WALL ABOVE THE 5' FOLDING COUNTER
32. SHALL INCLUDE (1) CABLE ACCESS DOOR ABOVE PERMANENTLY AFFIXED 8' FRONT MOUNT
COUNTER INTO CURBSIDE V‐NOSE COMPARTMENT
33. SHALL INCLUDE (1) WEATHERPROOF CABLE ACCESS DOOR (APPROX 6" X 6") THROUGH THE ROOF
INTO CURBSIDE V‐NOSE COMPARTMENT
34. SHALL INCLUDE (6) EXTERIOR TIE DOWN 12K D‐RINGS WELDED TO THE FRAME. TIE DOWNS SHOULD
BE DISTRIBUTED 3 PER SIDE AND AS EVENLY SPACE FRONT TO BACK AS POSSIBLE
35. ALL (6) TIRES SHALL BE 10 PLY ST205/75R15. WHEELS SHALL BE 15 INCH, 6 LUG PATTERN AT 2.75"
SPACING
36. TWO (2) 7,000 LBS RATED AXLES
37. 8" DOUBLE I‐BEAM MAIN RAILS, UNDERCOATED
38. 16" ON CENTER WALLS
39. 16" ON CENTER FLOOR SUPPORTS
40. SCREW‐LESS EXTERIOR SKIN ATTACHMENT
41. ONE PIECE ALUMINUM ROOF
42. RED/WHITE DOT TAPE
43. 3‐YEAR WARRANTY