684383201CG05 SDS.pdf

SAFETY DATA SHEET

Tile Red Non Flame Latex MIL-PRF-24596B; Color No. 22144

1. PRODUCT AND COMPANY IDENTIFICATION

MANUFACTURER

NCP Coatings, LLC 225 Fort Street Niles, MI, 269-683-3377

24 HR. EMERGENCY TELEPHONE NUMBER

CHEMTREC (US Transportation): (800)424-9300 CHEMTREC (International : 1(202)483-7616 Transportation)

2. HAZARDS IDENTIFICATION

EMERGENCY OVERVIEW

PHYSICAL APPEARANCE : Liquid IMMEDIATE CONCERNS : Harmful if swallowed.

CLASSIFICATION : Eye Irr. 2A, Acute Tox. 4 Oral

PICTOGRAMS

SIGNAL WORD : Warning

GHS HAZARD STATEMENTS : H302 Harmful if swallowed.

H319 Causes serious eye irritation.

GHS PRECAUTIONARY STATEMENTS : P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing.

P264 Wash thoroughly after handling.

P363 Wash contaminated clothing before reuse.

P403 Store in a well-ventilated place.

P501 Dispose of contents/container in accordance with local/national/international regulations.

DATE ISSUED : 6/15/2023

SDS REF. No : N-8858I

PRODUCT NAME: Tile Red Non Flame Latex MIL-PRF-24596B; Color No. 22144

PRODUCT CODE: N-8858I

PRODUCT USE: Refer to TDS and product label.

P301 + P310 IF SWALLOWED: Immediately call a POISON CENTER or doctor / physician.

P281 Use personal protective equipment as required.

P270 Do not eat, drink or smoke when using this product.

P280 Wear protective gloves/protective clothing/eye protection/face protection.

3. COMPOSITION/INFORMATION ON INGREDIENTS

Chemical Name Wt %

CAS Number

GHS

Aluminum Trihydrate 1-5% 21645-51-2 The substance does not meet the criteria for classification.

Propylene Glycol 1-5% 57-55-6 None known.

Ferric Oxide 1-5% 1309-37-1 Trime-1,3- Pentanediol, Monoisobutyrate

1-5% 25265-77-4 None known.

Titanium Dioxide 0.74 13463-67-7 Conclusive but not sufficient for classification.

* Toxic chemical subject to the reporting requirements of section 313 of Title III and of 40 CFR 372.

4. FIRST AID MEASURES

EYES : Immediately flush eyes with water. Flush eyes with water for a minimum of 15 minutes, occasionally lifting and lowering upper lids. Get medical attention promptly.

SKIN : Wash with soap and water. Get medical attention if irritation develops or persists. Remove contaminated shoes and clothes and clean before reuse.

INGESTION : DO NOT induce vomiting. Get medical attention immediately.

INHALATION : Rescuers should put on appropriate protective gear. Remove from area of exposure. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Keep victim warm. Get immediate medical attention.

MOST IMPORTANT SYMPTOMS AND EFFECTS, BOTH ACUTE AND DELAYED

SYMPTOMS : Eye irritant.

EFFECTS : Contact can cause burning, itching, redness, inflammation, and swelling.

5. FIRE FIGHTING MEASURES

SUITABLE EXTINGUISHING MEDIA : Water mist or fog, dry chemical, foam, carbon dioxide.

FIRE FIGHTING PROCEDURES : As in any fire, wear self-contained breathing apparatus pressure-demand (MSHA/NIOSH approved or equivalent) and full protective gear. Use water with caution, material may float and combust. Water may be ineffective in fighting the fire. Water spray to cool containers or protect personnel. Use with caution. Water runoff can cause environmental damage. Dike collect water used to fight fire. Small fires: carbon dioxide or dry chemical. Large fire: alcohol-type aqueous film-forming foam or water spray.

UNUSUAL FIRE AND EXPLOSION HAZARD : Material may combust at extreme temperature..

Empty containers retain product residue (liquid and/or vapor) and can be dangerous. DO NOT pressurize, cut, weld, braze, solder, grind or expose such containers to heat, flame, sparks, static electricity, or other sources of ignition. Also, do not reuse container without commercial cleaning or reconditioning.

COMBUSTION PRODUCTS : During combustion carbon monoxide and/or carbon dioxide may be formed.

6. ACCIDENTAL RELEASE MEASURES

SMALL SPILL : Eliminate all sources of ignition. Provide good ventilation and minimize the breathing of vapors and avoid skin contact. Dike spill area and absorb the spilled liquid with earth, sawdust or a commercially available absorbent. Shovel spent absorbent into recovery or salvage drums for appropriate disposal.

LARGE SPILL : Wear appropriate personal protective equipment. Eliminate all ignition sources.

Prevent additional discharge of material if able to do so safely. Do not touch or walk through spilled material. Avoid runoff into storm sewers and ditches which lead to waterways. Ventilate spill area. Stay upwind of spill. Use only non-combustible material for cleanup. Use clean, non-sparking tools to collect absorbed materials. Absorb spill with inert material (e.g. dry sand, earth or sawdust), then place in a chemical waste collector.

EMERGENCY PRECAUTIONS : Wear proper protective equipment.

7. HANDLING AND STORAGE

PRECAUTIONS FOR SAFE HANDLING : Use only in a well ventilated area. Avoid breathing vapor, fumes, or mist. Avoid contact with eyes, skin, and clothing. Ground and bond containers when transferring material. Use spark-proof tools and explosion proof equipment. Always open containers slowly to allow any excess pressure to vent. Follow all SDS/label precautions even after containers are emptied because they may retain product residues.

CONDITIONS FOR SAFE STORAGE, INCLUDING INCOMPATIBILITIES : Keep away from heat, sparks, and flame. Store containers in a cool, well ventilated place. Keep container closed when not in use.

8. EXPOSURE CONTROLS\PERSONAL PROTECTION

EXPOSURE LIMITS

Components CAS Limits Aluminum Trihydrate 21645-51-2 ACGIH TLV 10 mg/m3 TWA

OSHA PEL 15 mg/m3 TWA Propylene Glycol 57-55-6 OSHA PEL NE

ACGIH TLV NE

Ferric Oxide 1309-37-1 ACGIH TLV 5 mg/m3 TWA

OSHA PEL 10 mg/m3 TWA

Trime-1,3-Pentanediol, Monoisobutyrate

25265-77-4 OSHA PEL NE

ACGIH TLV NE

Titanium Dioxide 13463-67-7 OSHA PEL 10 mg/m3 TWA Total Dust

ACGIH TLV 10 mg/m3 Total Dust

OSHA TABLE COMMENTS:

NE = Not Established

ENGINEERING CONTROLS : Engineering controls should be in place to minimize exposure to vapors and any ignition sources.

PERSONAL PROTECTIVE EQUIPMENT

EYES AND FACE : Wear safety glasses with side shields, goggles, or a face shield.

SKIN : Wear impervious gloves to prevent contact with skin. Wear protective gear as needed -apron, suit, boots.

RESPIRATORY : NIOSH/MSHA approved respirators may be necessary if airborne concentrations are expected to exceed exposure limits.

WORK HYGIENIC PRACTICES : Do not eat, drink, or smoke in areas where this material is used. Avoid breathing vapors. Remove contaminated clothing and wash before reuse. Wash thoroughly after handling. Wash hands before eating.

OTHER USE PRECAUTIONS : Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower.

9. PHYSICAL AND CHEMICAL PROPERTIES

APPEARANCE : Liquid

ODOR : Typical

ODOR THRESHOLD : Not determined.

pH : Not determined.

MELTING POINT/FREEZING POINT: Not determined.

INITIAL BOILING POINT : 370 F BOILING RANGE: Not determined.

FLASH POINT AND METHOD : 220ºF(104ºC)

SETAFLASH CLOSED CUP

EVAPORATION RATE: Not determined.

FLAMMABILITY (SOLID,GAS): Not determined.

EXPLOSIVE LIMITS : 0.6 TO 17.4

VAPOR PRESSURE : Not determined.

VAPOR DENSITY : Not determined.

SPECIFIC GRAVITY : 1.3558573

SOLUBILITY: Not determined.

PARTITION COEFFICIENT: N-OCTANOL/WATER: Not determined.

AUTO-IGNITION TEMPERATURE : Not determined.

DECOMPOSITION TEMPERATURE: Not determined.

VISCOSITY: Semi-viscous.

VOC EPA METHOD 24 : 0.8988148 lb/gal

10. STABILITY AND REACTIVITY

STABILITY : No information available.

CONDITIONS TO AVOID : Avoid impact, friction, heat, sparks, flame and source of ignition.

INCOMPATIBLE MATERIALS : Prevent contact with strong oxidizing agents.

HAZARDOUS DECOMPOSITION PRODUCTS: During combustion carbon monoxide and/or carbon dioxide may be formed.

HAZARDOUS POLYMERIZATION : No information available.

11. TOXICOLOGICAL INFORMATION

SIGNS AND SYMPTOMS OF OVEREXPOSURE :

ACUTE EFFECTS :

EYE : Causes eye irritation.

SKIN : Causes skin irritation. Prolonged or repeated contact can result in defatting and drying of the skin which may result in skin irritation and dermatitis (rash).

INHALATION : Vapors are irritating to nasal passages and throat. High concentrations can cause stupor and headaches. May cause dizziness and drowsiness.

INGESTION : Irritating to mouth, throat, and stomach. May cause headache. May cause dizziness and drowsiness and/or stupor.

CHRONIC EFFECTS : Significant exposure to this chemical may adversely affect people with chronic disease of the respiratory system, central nervous system, kidney, liver, skin, and/or eyes.

Primary Route(s) of Entry: Eye Contact, Ingestion, Inhalation, Skin Contact

ACUTE TOXICITY VALUES : The acute effects of this product have not been tested. Data on individual components are listed below.

Aluminum Trihydrate(21645-51-2)

Acute toxicity not classified.

Propylene Glycol(57-55-6)

No hazardous items exist

Titanium Dioxide(13463-67-7)

Vapor LC50: >6.82lg/L Rat

Dermal LD50: >10,000 mg/kg Rabbit

Oral LD50: >5,000 mg/kg Rat

Trime-1,3-Pentanediol, Monoisobutyrate(25265-77-4)

Oral LD-50: (Rat): >3,200 mg/kg

Dermal LD-50:(Rabit): >15,200 mg/kg

LCLo (Rat, 6 h): > 2.73 mg/l (highest concentration tested)

12. ECOLOGICAL INFORMATION

ECOTOXICOLOGICAL INFORMATION: Information not available on mixture. Information on individual components is listed below if available.

Aluminum Trihydrate(21645-51-2)

No expected to be harmful to aquatic organisms.

Propylene Glycol(57-55-6)

No information available

Titanium Dioxide(13463-67-7)

96h LC50: >1,000 mg/L (fathead minnow)

72h EC50: 61 mg/L (green algae)

48h EC50: >1,000 gm/L (water flea)

Trime-1,3-Pentanediol, Monoisobutyrate(25265-77-4)

LC-50 (Fathead Minnow, 96h): 33 mg/l

EC-50 (Water Flea,48h): 147.8 mg/l

13. DISPOSAL CONSIDERATIONS

DISPOSAL METHOD : Dispose of waste in accordance with all local, state, and federal regulations.

14. TRANSPORT INFORMATION

UN NUMBER/ PROPER SHIPPING NAME/ TRANSPORT HAZARD CLASS/ PACKING GROUP

: NON-HAZARDOUS, NOT REGULATED

15. REGULATORY INFORMATION

REGULATORY OVERVIEW: The regulatory data in section 15 is not intended to be all-inclusive, only selected regulations are represented.

TSCA: All components of this material are either listed or exempt from listing on the TSCA Inventory. This material contains no substances that are subject to TSCA 12(b) export notification.

SARA TITLE III (SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT)

311/312/313 REPORTABLE INGREDIENTS: See Section 3.

EPA HAZARDS:

FIRE : No PRESSURE GENERATING : No REACTIVITY : No ACUTE : Yes CHRONIC : Yes

DSL: All components of this material are on or exempt from listing on the Canadian Domestic Substances List(DSL).

16. OTHER INFORMATION

HMIS RATING

Health : 2 Flammability : 1 Reactivity : 0 Personal Protection : G

HMIS and NFPA rating scale: (0=minimal hazard; 4=severe hazard)

REVISION INDICATOR : 1/31/23

MANUFACTURER DISCLAIMER : The foregoing data has been compiled from sources which the company, in good faith, believes to be dependable and is accurate and reliable to the best of our knowledge and belief. However, the company cannot make any warranty or representation respecting the accuracy or completeness of the data and assumes no responsibility for any liability or damages relating thereto or for advising you regarding the protection of your employees, customers, or others. User should consult OSHA and other applicable safety laws and regulations before use.

NFPA CODES

0 1