Minimum Specifications.pdf

MINIMUM SPECIFICATIONS

FOR MICROSEMI SYNCSERVER S650 GPS CLOCK

PR 1300964459

ITEM # MANUFACTURE

PART NUMBER

QTY DESCRIPTION

650-02-01-00-01-00-000000000001 Manufacture Configuration Code that identifies the assembled configuration of items 1-6.

1 090-15200-650 6 SyncServer S650 Base Unit Configuration, No Power Supply, No Option Modules NOTE: The Manufacture Configuration Code (650-02-01-00-01-00-000000000001) identifies the assembled configuration of this item (S650 Base Unit) and the remaining options listed below. Total configuration includes Items 1-6.

2 090-15201-002 6 Option: Dual AC Power Supplies (required at time of purchase) The dual-corded, dual-power supply option provides several levels of time service protection. The power supplies load share equally and there is an active power management system constantly monitoring the operation. If the power to one cord/circuit is lost or if one power supply fails, the entire load is instantly picked up by the remaining energized power supply with no interruption in time services to the network.

Connecting both power supplies to the same circuit provides protection against a single power supply failure. In the event of a power supply failure, notification is instantly provided to the network operator through SNMP trap or email. For extra level of assurance, the power cord(s) supplied with the SyncServers have locking rear IEC 60320 connectors to avoid accidental decoupling.

3 090-15201-003 6 Option: SyncServers OCXO Upgrade (required at time of purchase)

The oven-controlled crystal oscillator (OCXO) upgrade improves the holdover accuracy beyond the standard oscillator, though not nearly as much as the rubidium oscillator. OCXO holdover accuracy is 25 μs for the first day. Depending on the level and duration of accuracy needed, the OCXO is a compromise between the standard oscillator and the rubidium oscillator.

4 090-15201-006 6 Option: SyncServer Standard Timing I/O Module (required at time of purchase)

The Timing I/O module is a time and frequency input and output module option. Its standard configuration supports fixed input for the two input BNCs (J1–J2) and six output BNCs (J3–J8) with output time codes, sine waves, and rates.

5 920-15201-109 6 Option: Flex Timing Option for Timing I/O Module

The FlexPort timing option enables the six output BNCs (J3–J8) of the Standard Timing I/O Module to output any supported signal. Similarly, the two input BNCs (J1–J2) can support a wide variety of input signal types. This “any signal, any connector” configuration makes efficient and cost-effective use of the 1U space available.

6 990-15202-100 6 Option: Antenna Kit: 100 ft. total length: 100 ft. Cable, (GPS/GLONASS) The standard antenna used with the SyncServer S600/S650 is a high-gain (40 dB) GNSS antenna covering the GPS L1, Galileo E1, GLONASS L1, and SBAS (WAAS, EGNOS, QZSS and MSAS) frequency band (1575 MHz to 1606 MHz). The antenna has a three-stage low-noise amplifier, with a mid-section SAW with a tight pre-filter to protect against saturation by high- level sub-harmonics and L-Band signals. An L-bracket for pole mounting and 3-foot BNC(m) to N(f) cable is also included.