Material Ordering Data 21731201.doc

MATERIAL ORDERING DATA

ASTM-B-369

IDN: N4523A 2173-1201

ICN: 38RNL52401

KO: S01

KOI: 001

Paragraph 5 Ordering Data

A. ASTM-B-369/B369M, STANDARD SPECIFICATION FOR COPPER-NICKEL ALLOY CASTINGS, dated 01 APRIL 2020.

B. Quantity of castings:1ea Item 35 C. Copper Alloy UNS number (Table 2): FORMDROPDOWN

D. Pattern or drawing number: 120-4326543 Rev Z Condition (as-cast, machined, and so forth): Machined E. ASME Boiler and Pressure Vessel Code Requirements: FORMDROPDOWN

F. When material is purchased for agencies of the U.S. Government, the Supplementary Requirements of this specification may be specified.

G. The following are optional and should be specified in the purchase order when required:

FORMCHECKBOX

Pressure test or soundness requirements (Specification B 824)

FORMCHECKBOX

Witness inspection (Specification B824)

FORMCHECKBOX

Certification (Specification B824)

FORMCHECKBOX

Foundry test report (Specification B824)

FORMCHECKBOX

Product marking (Specification B824)

FORMCHECKBOX

Weldability test

FORMCHECKBOX

Approval of weld procedure and records of repairs

H. Supplementary Requirements:

FORMCHECKBOX

S1 – Referenced documents

FORMCHECKBOX

S2 – Soundness

FORMCHECKBOX

S3 – Pressure test

FORMCHECKBOX

S4 – Weld repair

FORMCHECKBOX

S5 – Quality Assurance

FORMCHECKBOX

S6 – Product marking I. Preparation for delivery:

S7.1 – Preservation, packaging, and packing is required: Level C The material shall be separated by size, composition, grade, or class and shall be preserved and packaged, Level A or C, packed, Level A, B, or C as specified in the contract or purchase order, in accordance with the requirements of Practice B900.

S7.2 – In addition to any special marking required by the contract or purchase order, marking for shipment shall be in accordance with MIL-STD-129.

Additional Data Requirements:

5.2.3 - Certification: Limited to chemical and mechanical results only

Provide a report of NDT results per section 12.5.6 of S9074-AR-GIB-010/278, excluding item (d).

5.2.5 - Product Markings - Mark castings per Note 5 of DWG 120-4326543. Upon acceptable pressure test and visual inspection each casting shall have its heat number marked on the raised pad. To record the heat number the casting may be marked by vibro tool, or round bottom low stress stamps, per MIL-STD-792.

S2 - Soundness - Each casting is Category 3-I.

See additional Information attachment for testing clarification/requirements

Prepared By: Amanda White

Code: 260.7