Casting Drawings.docx
DOCX document 149 KB Posted
- Attached to
- casting Federal contract opportunity
- Solicitation number
- SPMYM222Q2406
View the file
Other files for this federal contract opportunity
| File | Type | Posted |
|---|---|---|
| Material Ordering Data 21731200.doc | DOC document | |
| Material Ordering Data 21731201.doc | DOC document | |
| CDRL Exhibits A-E 21731200.pdf | ||
| SPMYM222Q2406.pdf | ||
| CDRL Exhibits F-H J-K 21731201.pdf |
On GovTribe
Work with this file on GovTribe
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
Item 76A
1ea Item 34 Notes:
1. Not used.
2. When backside of flanges are not machined, spot facing for all bolt heads and nuts is required. This spot face shall not cut more than 1/32 inch below the minimum flange thickness.
3. The machine surface finish of mating surfaces on flanges shall be as follows:
A. Flanges size 12” and below must have a finish with a circular lay (concentric or phonographic) of 125 to 1000 RHR produced by machining 30 to 80 cuts of uniform depth per inch of face width.
B. Flanges over a nominal size of 12” to be same as above except that 21 to 80 cuts per inch of face width shall be used.
4. All flanges are in accordance with MIL-F-20042.
5. The foundry’s name or trademark, the item number (“Item X”) and DWG number (4326543), 100 PSI, and the size are to be cast in ½” raised letters on each casting; also each casting is to be provided with a 1/16” min. thick raised pad for the heat number and non-destructive test information. Pad to be about 1-3/4”x2”.
Notes 6-7 are not used.
11. Tolerances for the center to end, branch location and flange O.D. Dimensions for the Sea Chest Castings are to be as shown in table:
| Dimensions |
| Tolerances |
| 2 to 5 |
| +3/32 -1/16 |
| 5 to 8 |
| +1/8 -3/32 |
| 8 to 12 |
| +3/16 -1/8 |
| 12 to 15 |
| +1/4 -3/16 |
| 15 to 30 |
| +1/4 -1/4 |
image1.png image2.png
File details come from the government source that posted it. Updated .