SMALL ARMS LTC
Added: Sep 22, 2015 11:49 am
THIS SOLICITATION WILL OPEN ON OR AROUND OCTOBER 8TH, 201524 of these items are listed on the QUALIFIED SUPPLIERS LIST OF MANUFACTURERS (QSLM) - FSCs 1005(Guns, through 30 mm), 1010 (Guns, over 30 mm through 75 mm), 1015 (Guns, over 75 mm through 125 mm),1020 (Guns, over 125 mm through 150 mm), 1025 (Guns, over 150 mm through 200 mm), 1055 (Launchers,rocket and pyrotechnic), and 1095 (Miscellaneous weapons) (APR 2014)(a) Only the following shall be eligible for award (except as provided in paragraph (d) of this clause):(1) Offers from approved sources listed in the Item Description; or(2) Offers from manufacturers listed or qualified for listing (as determined by the contracting officer) on the DLALand and Maritime Qualified Suppliers List of Manufacturers (QSLM) for FSCs 1005, 1010, 1015, 1020, 1025,1055, and 1095 at the time of award; or(3) Offers from authorized distributors of approved or QSLM qualified sources (as determined by the contractingofficer) (see (1) and (2) above) with adequate traceability (as determined by the contracting officer) to theapproved or QSLM qualified source(b) The Government may terminate the Contractor's QSLM status at any time for failure of the Contractor tomaintain compliance with the provisions and qualification criteria governing the QSLM for FSCs 1005, 1010, 1015,1020, 1025, 1055, and 1095. Maintaining QSLM status is a contractual requirement; therefore, the ContractingOfficer may terminate the contract for default for the Contractor's failure to maintain such status throughout theperiod of contract performance.(c) As required in the DLA Land & Maritime "Criteria and Provisions for Qualified Suppliers List ofManufacturers" (Criteria), the contractor shall provide, at the Government's direction, the results of the mandatorytesting at any time after award, until the record retention period has expired, as referenced in the Criteria andlisted in JEDEC Standard JESD 31.(d) In the event no offers are received on this solicitation from a source listed in paragraph (a) of this clause, theGovernment reserves the right to make an award based on offers received and found acceptable by other meansof testing or verification, as deemed acceptable by the Government.(e) The provisions governing qualification and the applicable qualification criteria for the QSLM, theapplication form, and a listing of the affected NSNs may be obtained-(1) From the QSLM general information web page, found athttp://www.landandmaritime.dla.mil/offices/sourcing_and_qualification/offices.aspx?Section=QSA(2) By sending an email to DLALandandMaritimeQSLM@dla.mil;(3)(i) By writing to the following address when using the United States Postal Service (USPS):DLA Land and MaritimeAttention: VQP ChiefPost Office (P.O.) Box 3990Columbus, Ohio 43218-3990; or(ii) By writing to the following address when using private carriers, to include United Parcel Service (UPS) orFederal Express (FEDEX):DLA Land and MaritimeAttention: VQP Chief3990 East Broad StreetColumbus, Ohio 43213( X ) The solicitation will be available in FedBizOpps on its issue date of APPROXIMATELY 15 DAYS AFTER THEREQUIREMENT HAS BEEN SYNOPSIZED( x ) The Small Business size standard is__1000_______employees.( X ) Drawings/specifications will be available through DIBBS solicitation link in the synopsis on the solicitationissue date.( ) Specifications, plans or drawings are not available.( ) Proposed procurement contains a % option for increased quantities.( X ) The proposed procurement contains an option to extend the contract period one or more times at thediscretion of the government. The total duration (base plus option years) shall not exceed __5___ years.( X ) This proposed procurement includes a family group of items within the Federal Supply Classes of 1005, 1010and 1095.( ) This acquisition is for supplies for which the Government does not possess complete, unrestrictive technicaldata; therefore, the Government intends to solicit and contract with only approved sources under the authority of10 U.S.C. 2304(c)(1). Approved sources are listed on the attachment.( ) It is anticipated that award will be made via a delivery order to an existing basic ordering agreement.( X ) While price may be a significant factor in the evaluation of offers, the final award decision will be based upona combination of price, delivery, past performance and other factors as described in the solicitation.( ) Place of performance unknown. This contract is subject to the Service Contract Act and the place ofperformance is unknown. Wage determinations have been requested for(insert localities)The contracting officer will request wage determinations for additional localities if asked to do so in writing by(insert time and date).( ) This acquisition is limited to eligible 8(a) concerns only. NAICS Code ______. Eligibility to participate may berestricted to firms in either the developmental or transitional stage. Interested 8(a) concerns should request copiesof this solicitation as soon as possible since the solicitation will be issued without further notice upon SBAacceptance of the requirement for the Section 8(a) program.( ) Restricted Rights Data Restrictions apply.( ) Various Increments Solicited:FROM: TO:10. TYPE OF SET-ASIDE: Total Small Business Set-AsideBased upon market research, the Government is not using the policies contained in Part 12, Acquisition ofCommercial Items, in its solicitation for the described supplies or services. However, interested persons mayidentify to the contracting officer their interest and capability to satisfy the Government's requirement with acommercial item within 15 days of this notice.These items have technical data some or all of which are subject to export-control regulations, distribution of thetechnical data and eligibility for award are limited to those suppliers qualified through JCP certification, or to thoselicensed by either the Departments of State or Commerce; or to foreign suppliers pursuant to internationalagreements. To apply for JCP certification, complete DD Form 2345, "Military Critical Technical Data Agreement,"form is available at the World Wide Web address http://www.dlis.dla.mil/jcp or by writing to:DLA Logistics information ServiceFederal Center74 Washington Ave., NorthBattle Creek, MI 49017-3084To manufacture these item, non-JCP cerfified suppliers must submit a current manufacturing license agreement,technical assistance agreement, distribution agreement or off-shore procurement agreement approved by theDDTC with the offer, unless an exemption under the provisions of ITAR section, 125.4 "Exemptions of GeneralApplicability," and /or Part 740 are applicable. Non-JCP certified suppliers seeking export controlled technical dataare required to provide the contracting officer with an applicable agreement or identify which ITAR/EAR exemptionapplies to receive a copy of the export controlled technical data.Note: JCP certified contractors who receive technical data pursuant to their DD Form 2345 certification may notfurther disseminate such data unless further dissemination of the technical data is expressly permitted by DODD5230.25"These items are ‘Defense Articles' as defined in and subject to the International Traffic in Arms Regulations (ITAR)(22 C.F.R. 120-30) and the Arms Export Contract Act (22 U.S.C.A. 2778-2799). Any manufacturer or exporter ofDefense Articles is required to register with the Directorate of Defense Trade Controls (DDTC), U.S. Departmentof State. Documentary evidence of registration may be required prior to award. Additional export restrictions applyas indicated herein. Failure to submit DDTC registration when requested will make an offer ineligible for award.These items require Government Furnished Equipment (GFE) and Government Furnished Material (GFM). Asecurity Pre-Award Survey is required for these items. DFARS, Part 252.223-7007, ‘SAFEGUARDING SENSITVECONVENTIONAL ARMS, AMMUNITION AND EXPLOSIVES' shall be part of the solicitation/contract.
SPE7MX-15-R-0108 Defense Logistics Agency Land and Maritime
9/22/15, 11:49 AM