UTV Pump Package

Added: Jul 20, 2016 9:42 am This is an intent to sole source to MTech Inc., 1072 Marauder Street, Suite 210, Chico, CA 95973.

If anyone has the ability to satisfy these requirements, please contact Peggy Dobie by email at pdobie@fs.fed.us by July 27, 2016, 12:01 p.m.

Provide a UTV Slip-on Tank and Pump with the following specifications:
Tank
The tank shall have the following characteristics:
• Serves as the main load bearing structure for the skid (e.g. skid structure and tank are one and the same)
• MTECH PolyToughTM extrusion-welded Copolymer Polypropylene construction
• Capacity of 75 gallons of water
• 3/8" internal baffles with interlocking design to meet NFPA standards
• Pump suction plumbed to the center of the tank with anti-cavitation device
• Minimum 1" tank drain that can be readily removed or opened by hand
• Threaded 6" fillwell, flush mounted at top of tank
• Tank vent
• Site tube to gauge water level
• Integral lift handles so the skid can be unloaded and loaded by hand when empty
• Tie down points or flange-mounted anchor points to secure the skid unit to the UTV bed
• Mounting pad for either a hose rack or hose reel
• Sized to fit in the bed of a 2015 Polaris 800 EFI 4x4 with tailgate in the upright position
Pump & Engine
The pump system shall have the following characteristics:
• 5.5 Horse Power Gasoline engine (4 cycle) with recoil start
• 2" Centrifugal pump
• 1-1/2" suction port
• 1-1/2" discharge port
• ¾" booster discharge
• Cooling return so that discharge can be completely stopped without causing a risk for pump overheating
• All plumbing to be of either composite polypropylene, brass, or stainless steel