Pringle Falls Electric Upgrade

Added: Aug 02, 2017 1:00 pm The Contractor shall pull the existing #10 wire out of the one inch conduit from the MDP Meter/Panel to the Garage Panel and save the exist ground wire for future use . The Contractor shall remove the existing panel and mark the existing circuit wires to relocate into the new panel. The Contractor shall provide and install one new 60 Amp Panel with Main Breaker (Square D Model # QO48M60DSGP or similar model) with six 20 Amp breakers to replace the existing 30 Amp fused panel in the Garage. The Contractor shall install approximately 100 feet of new, #6 Cu, THHN/THWN wire, the existing #10 ground wire from the MDP Meter/Panel to the Garage maybe reused. Reattach the old circuits to the new panel in the Garage and add (3) new GFI circuits with two outlets (12 Gauge wire run to each outlet) on each circuit according to current NEC and State of Oregon Electrical Code. Ground the new panel according to NEC to the existing Ground Rods and test all circuits after completing installation.

The allotted time for this contract is 30 days from the notice to proceed. Pre-proposal Site Visit - Upon Request.

Location: Head Northeast on Highway 97 toward Bend, Oregon for approximately 2.6 miles. Turn left at Burgess Road Loop and proceed for approximately 7.6 miles. Turn left into the second driveway approximately 1/8 mile pass the Deschutes River into Pringle Falls Experimental Forest Headquarters driveway.

The magnitude of this project is less than $25,000. This acquisition is 100% set-aside for Small Business concerns under NAICS Code 238210. Offerors shall submit all questions in writing by August 16, 2017. Questions shall be sent to asalas@fs.fed.us. Submit your proposal electronically to asalas@fs.fed.us, no later than August 23, 2017 11:00am MT.