SOW.docx

STATEMENT OF WORK

FOR

3rd Battalion, 160th Special Operations Aviation Regiment (Airborne) Bulk Fuel Containment System

29 January 2018

Prepared by CW2 William G. Gallerani III Battalion Maintenance Officer 3rd Battalion, 160th Special Operations Aviation Regiment (Airborne) Bldg. 5008 N. Lightning Rd.

Hunter AAF, GA 31409

1. SCOPE

3rd Battalion 160th SOAR (Abn) is looking to acquire one additional bulk fuel containment system for the motor pool. This system is a requirement to meet all applicable environmental and federal regulatory guidelines for the storage of bulk Petroleum, Oils, and Lubricants.

1.1.1 DIMENSIONS

The machine must have the minimum specification as listed below.

· Height: 6-inches (15.24 cm)

· Width: 10-feet (3 m)

· length: 28-feet (8.5 m)

· Storage Capacity: 835 gallons

1.1.2 Standard Features

· The berm must be of a one-piece steel containment construction with tubular sidewalls.

· The berm must have both end walls include Ramps, 18”up / 18”down, peak at 6” high ramps for pull-through and push-through capability.

· The ramps must be integral (welded into) to the containment and form end walls.

· System would be encapsulated in a 62mil protective coating of structural fiberglass with glass mesh imbedded into the resin.

· The berms must have Safety Yellow ramps, line of site poles for all four corners, and (2) drain ports on the same end.

· The system will include a filter berm and ball valve for controlled and safe release of rainwater.

Warranty

● The structure and welds should be guaranteed by the Manufacturer for five years: the coatings for three years.

2. REQUIREMENTS

2.1 Core

2.1.1 The vendor must have the equipment in stock and be able to deliver equipment in an appropriate amount of time

2.2 Period of Performance

2.2.1 The delivery of equipment needs to be within the appropriate amount of days

2.3 Place of Performance

Not applicable

2.4 Contractor Personnel

2.4.1 Contracted personnel will perform the necessary operations and maintenance activities in order to meet the prescribed requirements within the SOW

2.5 Administrative Considerations

2.5.1 Contractor-Furnished Items and Services, except for those items or services specifically tested as Government furnished, the contractor shall furnish everything needed to perform this contract according to all its terms

2.6 Environmental and Hazardous Materials Handling

2.6.1 The contractor shall perform the requirements of this SOW in an environmentally acceptable manner consistent with Army, federal, state, and local environment laws and regulations.

2.6.2 The contractor shall follow established policies and procedures that minimize the risk of environmental pollution

2.6.3 The contractor shall follow Army, MACOM, and restricted area regulations/instructions and local plans and procedures concerning the handling of potentially hazardous/toxic materials

2.6.4 The contractor shall cooperate with airfield officials in conducting inspections, resolving incidents, and take corrective action to prevent recurrence, where the release of hazardous/toxic materials occurs within the contractor’s area of responsibility as defined in this SOW

2.6.5 The contractor shall follow established programs to safely and properly use, manage, store, control, and dispose of combustible, flammable, and hazardous materials.

2.6.6 Revision: Revisions to the plan to assure contractor compliance to the requirements of the SOW and contract/task may be required at any time during performance of the contract. The contractor shall make appropriate revisions and obtain acceptance of the revised plan from the PCO.