TECHNICAL ORDERING DATA.docx

Restricted Access Orbital Weld Head and off board wire feeder Document Number: 0082-3348

· Must be compatible with Liburdi P300 Power Supply

· Must be compatible Miller Coolmate 3 water cooler

· Must be compatible with Liburdi brand leads, cables, and parts

· Must include offboard wire feeder Must have the following Axes specifications:

· Travel – rotational speed of 0.3 – 2.5 RPM

· Automatic voltage control: Linear speed of 5-40 IPM

· Oscillation: Linear speed of 5-50 IPM

· The service linear must be manual

· The wire speed – Linear must be up to 75 IPM Must have the following Module specifications

· Must include service module

· Must include oscillation module

· Must include Weld head

· Must include Adapter Plate

· Must include off-board wire feeder Must have the following dimension specifications

· Weld head assembly must be 17.72” W X 16.43” L Overall

· Weld Head assembly (Including oscillation module) must be 7.62” in height

· Weld Head assembly (Excluding oscillation module) must be 1.56” in height

· Must have a Max Oscillation height of 14.9”

· Must have a Max service advanced length of 28.7”

· Must have a Min Oscillation height of 13”

· Must have a Min service retracted length of 21.4”

· Weld head must have a diameter of 11.8”

· Must have a radial clearance of 6” (Radius)

· Must be able to hold a MAX of 4” NPS Pipe and a Min of 2” NPS Pipe

Torch must have the following specifications

· Torch must be designed to accept consumables from 2 series “stubby” (Vender: CK Worldwide. Cup is P/N: PSNS2AG75 and Gas lens P/N: PSNSGL332)

· Torch must be water cooled

· Must have a current rating of 200 AMPS Must have the following torch tilt specifications

· Must have a gear driven worm tilt assembly

· Must have up to + / - 10° tilt

· Must be able to adjust tilt with a 3mm Hex driver and must be standard across all adjustments on the weld head assembly Must have the following wire manipulation specifications

· Must have an in/out of +/- .078”

· Must have an up/down of +/- .078”

· Must have full wire manipulation range when tilting above the horizontal

· Must have full wire manipulation range when tilting up to 5° below the horizontal

· 3mm Hex Driver Utilized (standard across all adjustments on head) Off-Board wire feed module must have the following specifications

· Must be configurable to mount 8” or 12” wire spools

· Must have up to 75 IPM wire feed speed

· Windows must be made from tinted polycarbonate The Oscillation Module must have the following specifications

· Must have a height of 5.8”

· Must be 3.8” W X 3.7” L

· Must have a belt driven ball screw axis with a linear rail

· Stroke must be +/- 7/8”

· Must have encoder and potentiometer feed back The service Module must have the following specifications

· Must be 8.8” H X 14” L X 5.8” W

· Must utilize a locking high-load carriage

· Must have a dynamic load rating of 2800 lbs.

· Must have a service stroke of 7.25”

· Must be designed to allow access to torch components without losing welding position