Tab 04 SOW.pdf

STATEMENT OF WORK

1. Objective/Requirements

The information listed below is required to complete this purchase.

2. Characteristics, Scope, and Specs

LINE PART NO. DESCRIPTION QTY.

1 OBSIDIAN-R8w OBSIDIAN Rugged Waterproof Fanless Rack System with:

- Linux operating system

- Built in Gate

- fits up to 8 Modules

- DEWESoftX-PROF

- Redundant ECAT interface for DAQ and control;

- Bus1: 2x Lemo 1T8;

- Bus2: 2x RJ45;

- GLAN and USB3.0 (type C) interface;

- Internal storage: 4 GB;

- Expandable storage with SD card, or external disk over USB-C (not included);

- 2x CAN 2.0b BUS isolated on DSUB9m;

- 2x SYNC (L00T4f);

- Redundant power input (L1T2m): 9...48 VDC;

- Wifi/BLE module;

- 10Hz GPS receiver (BeiDou, Galileo, GLONASS, GNSS, GPS);

- LED indication/status lights;

**Power Supply (PS-120W-L1T2f) not included

- Includes RJ45-RJ45w-3m communication cable

*Requires IOLITErw slices to obtain an IP rated system.*

2 PS-120W-L1T2f AC/DC Power supply

- 120W

- 24V

- 5A

- all approvals

- LEMO 2 pin connector

- For OBSIDIAN-R8w

3 L1T2f-BAN-2m DC-power supply cable

- LEMO 2pin to banana

- 2m

- for OBSIDIAN-R8w

4 L1T8m-RJ45-1m Communication cable for ECAT

- ECAT (L1T8m) to Computer (RJ45)

- Operational temp: -40 to 85C

- Enviro Spec: IP67

- Length: 1m

**Does NOT provide power**

*For daisy chaining IOLITE (distributed) into Krypton*

5 RJ45-RJ45w-3m Standard CAT6 Ethernet LAN Network shielded cable with one waterproof end.

- Length: 3 meter.

**Does NOT provide power**

6 IOLITErw-6xSTG 6 Channel IOLITE STG Module

- IP67 Rated when properly used with OBSIDIAN-R8w.

- Input modes: Voltage, Strain, Resistance, Potentiometer, Current

- Voltage ranges: +/-50 V, 10 V, 1 V, 100 mV

- Current ranges: +/-20 mA, internal 50 R shunt

- Strain ranges: 2 mV/V .. 1000 mV/V

- Internal 1/2 bridge and 1/4 bridge (120R and 350R) completion

- shunt and short CAL function; Input coupling: DC or AC (1Hz)

- Excitation: 0 .. 24 V unipolar, 0 .. 12V bipolar

- A/D converter: 24 Bit oversample SAR, 20 kS/s, with AFF

- TEDS, DSI adapter compatible; Input connector: DSUB

*IOLITErw cards can only be used in an OBSIDIAN-R8w, OBSIDIAN-R12 or

IOLITE-R12

7 IOLITErw-4xCNT 4 Channel IOLITE Supercounter Module

- IP67 Rated when properly used with OBSIDIAN-R8w.

- Timebase: 100 MHz (~5 ppm)

- Input modes: Event-, Timing- and Sensor counter; 3xDI

- Input compatibility: CMOS/TTL

- Max. Input level: +/-25 Volt continuous (40V peak)

- Max. acquisition rate: 20kS/s

- Sensor supply: 5 V /100 mA, 12 V / 50 mA

- Input connector: Lemo L1T7f

*IOLITErw cards can only be used in an OBSIDIAN-R8w, OBSIDIAN-R12 or

IOLITE-R12

8 SIRIUSi-8xSTG 8 Channel SIRIUS Isolated STG Module

- 8 Channels of strain, RTD, Potentiometer and voltage inputs (9-pin D-SUB) Programmable sensor and bridge excitation up to 20V/800mW or 60mA/500mW Internal 1/2 bridge and 1/4 bridge (120R and 350R) completion 2x bipolar shunt and short CAL function 3, 4, 5, 6 wire connection Voltage ranges(DualCore): +/-50(1) V, 10(0.5) V, 1(0.05) V, 100(5) mV Strain ranges: 2 mV/V ... 500 mV/V free programmable with Dual Core Input coupling: DC or AC (1Hz, 3 Hz or 10 Hz) A/D converter : 2 DUAL CORE 2 ranges each 24bit sigma delta With anti-aliasing filter, 200kS/s sampling rate per channel Total Dynamic range 152dB All I/O fully galvanic isolated +-1kV

TEDS, DSI -adapter compatible

- 1x CAN 2.0b BUS isolated (9-pin D-SUB on back)

- 2x Sync port (4-pin LEMO on back)

- 1x Power In (6-36 VDC needed) (2-pin LEMO on back)

- 1x Power Out (2-pin LEMO on back)

- 1x GND port (4mm Banana plug on back)

- 1x USB2 with Locking connector (port on back)

Includes:

- DEWESoft-PROF + OPT-CAN

- AC power supply with 24VDC out

- USB-MINI cable with locking screws

- Grounding cable

3. Place of Performance

NASA/ Kennedy Space Center COMET Warehouse K6-1547 Kennedy Space Center, FL 32899

4. Period of Performance

Estimated delivery lead-time is 30 days ARO.