Statement of Work.pdf

Statement of Work

1. USS KEARSARGE (LHD 3) requests immediate consideration of contracting services through NAVSUP FLC Norfolk for work on the Refrigeration Systems in each galley onboard. This work is to correct a critical safety shortfall and as such must be remedied as soon as possib1e to minimize risk to crew health. Additionally, due to ship operational commitments, there is a very limited window to execute repairs. All repairs must be completed by 19 Feb 2021. This statement of work requires the contractors replace the current degraded reefer components in the Wardroom galley, beverage line, Commanding Officer galley, Flag Galley, Mess decks, CPO Galley, and the Bake Shop.

2. Period of Performance: 22 January 2021 - 19 February 2021

3. Breakdown of requirements: Refrigeration onboard USS KEARSARGE (LHD 3), provides safe and proper storage of food provisions. These specific reefer components are not properly functioning and in need of a total groom.

Wardroom Galley R65-2M-SN-MLR S# 1403-06:

Degrease condenser Replace bottom middle light actuator Replace all latches and strikes Re-calibrate thermometer Re-mount sensor bulb Change all 4 small door gaskets Provide 3 shelves, 4 brackets, and clips

Wardroom Galley UCR20//S# 6373-00:

Degrease condenser Replace mullion heaters and breaker strips Replace cork tape Provide 4 hinge covers Replace gaskets Provide 2 new shelves with brackets Install light bulb with cover

Mess Deck ER5-1368H S# 2322:

• Degrease condenser

• Replace evaporator drain line

• Replace door gasket

• Re-install on/off switch

Mess Deck ERS-13688 STBD//S# 2321:

Replace existing skid with Rl34a skid and evaporator Replace condensate drain lines

• Replace suction service valve

• Repair door latch

• Replace gasket, door actuator and bulb

• Calibrate thermostat

• Re-install on/off switch

Mess Deck ER5-1368H PORT//S# 2320:

• Provide label ID tag

• Provide I junction box cover

• Replace access louvered panel Replace thermostat knob Replace compressor Replace skid and line set/cap tube system Provide light cover Provide front pilasters, shelves and brackets

Mess Deck ERS-1368H///S# 2319:

• Provide cable ID tag

• Provide screws for access panel

• Insulate suction line

• Install emergency switch

• Provide screws for evaporator

• Adjust latch on door

Mess Deck UCF10//S#1827-19:

• Repair broken condenser

• Replace skid

• Replace fan motor

• Replace gaskets on door

• Install on/off emergency disconnect

CPO Galley:

Provide cable ID Provide junction box cover Degrease condenser Repair leaks Re-wire evaporator

CPO Galley UCR20//S#1414-06:

Secure reefer to deck Tighten loose door latches Replace gaskets Straighten fins on evaporator

CPO Galley UCFS//$#9750-12:

• Calibrate freezer thermostat

• Degrease skid

• Replace evaporator fins

CPO Mess CFC3T//S#0383-04 salad bar:

• Replace existing 15amp breaker with 20amp breaker

• Re-wire salad bar

• Degrease condenser coil

• Replace door gasket

• Replace light actuator and bulb

Main Galley ERS//S# 2918:

Install skid Add new line set brazed in-pressure Install condensate pans Replace box thermostat Re-route drain line Provide grill for evaporator fan Replace entire door assembly to include gasket, latch, strike and hinges Replace electrical conduit Install emergency disconnect toggle switch Install new electrical box

Bake Shop RSO//S# 1413-06:

• Mount found controller

• Degrease condenser

• Provide mounting channels and skid clips for access grill

• Repair door latches and strikes Replace gasket on bottom right door Install shelves, clips and brackets Replace interior light Repair mullion heaters Replace missing breaker strips

Bake Shop RSO//S# 1410-06:

Mount LP switch to skid

• Degrease condenser

• Replace bottom right door gasket

• Provide access grill channel, screws and skid clips

• Replace evaporator drain line Replace light and light cover Repair mullion heater breaker strip

Bake Shop RSO//S# 1412-06:

Mount LP switch Degrease condenser Provide shelves and clips Replace light and light cover

Wardroom Beverage Line:

• Replace Silver King gasket

• Calibrate thermometer

Commanding Officer Galley:

• Refill refrigerant in freezer

• Tighten evaporator fan

• Replace drain line heater and drain guard cover

• Seal off box penetrations

• Mount connection boxes

• Replace door hinge cover

• Re-mount temperature gauge

• Replace on/off label

• Replace reefer door light actuator

F1ag Galley:

• Mount junction boxes

• Degrease condensing units

• Refill freezer refrigerant

• Provide 8 shelf brackets

• Install cable ID tags on both inlet power lines

• Restore drain line heater

4. Permitted working hours are 0700-2200 Monday - Sunday during the period of performance.

5. Upon completion, all systems will be OPTESTED with a ship's force representative present, preferably with the Food Service Officer.

6. The use of proper personal protective equipment (ear protection, eye protection, respirators) is highly encouraged as needed.

7. It is the responsibility of the contractor to remove and dispose of any hazardous material they bring onboard to complete the job. Furthermore, hazardous material is not to be left unattended at any time.

8. Please forward any questions to Connie Totaro at connie.totaro1@navy.mil.