EDR.pdf
PDF 15 KB Posted
- Attached to
- Gear Assembly, Speed Federal contract opportunity
- Solicitation number
- SPRHA5-20-Q-0450
- Issued by
- Defense Logistics Agency Aviation
View the file
Other files for this federal contract opportunity
| File | Type | Posted |
|---|---|---|
| CDRL.pdf | ||
| SPRHA520Q0450.pdf | ||
| MQR.pdf | ||
| SOW.pdf | ||
| EDL.pdf |
On GovTribe
Work with this file on GovTribe
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
REV: ENGINEERING DATA REQUIREMENTS
(ATTACHMENT “A”)
NOTE: MILITARY SPECIFICATIONS / STANDARDS WILL NOT BE FURNISHED IN THE BID SET.
1. THE FOLLOWING INSTRUCTIONS ARE FURNISHED FOR THE MANUFACTURE OF:
GEAR ASSEMBLY,SPEED
2. PART NUMBER:
200927771
3. NATIONAL STOCK NUMBER:
3010-01-315-5148FD
PREPARED BY:
KENDRIC HORNSBY
OFFICE SYMBOL:
415 SCMS/GUMBC
DATE:
20191001
HILL AFB FORM 462 Page 1 of 1
4. THE FOLLOWING SPECIFICATIONS/STANDARDS, ETC., WILL BE USED IN LIEU OF THE DATA INDICATED. THE SUPERSEDED DATA
WILL NOT BE FURNISHED UNLESS SO INDICATED.
5. THE SOURCES/MATERIALS IF LISTED ON THE STANDARDS, SPECIFICATION AND DRAWINGS ARE THE ONLY SOURCES/MATERIALS FOR THOSE ITEMS. SUBSTITUTIONS SHALL HAVE PRIOR APPROVAL BY THE COGNIZANT ENGINEERING
ACTIVITY.
6. DEVIATIONS FROM SPECIFICATIONS IDENTIFIED IN CONTROL DRAWINGS ARE NOT AUTHORIZED WITHOUT PRIOR APPROVAL
BY THE COGNIZANT ENGINEERING ACTIVITY.
7. SYSTEM ENGINEER RETAINS ALL RIGHTS TO REVIEW AND ACCEPT DISCREPANT ITEM PRIOR TO SHIPMENT. ANY DEVIATION FROM THE ENGINEERING DRAWING SHALL BE SUBMITTED FOR ENGINEERING REVIEW AND DISPOSITION.
8. PRIOR TO CONTRACT AWARD, THE CONTRACTOR SHALL CERTIFY TO THE GOVERNMENT IN WRITING FULL COMPLIANCE WITH DRAWINGS, SPECIFICATIONS AND STANDARDS CALLED OUT AND REQUIRED FOR THE MANUFACTURE OF THIS ASSEMBLY. THE CONTRACTOR IS RESPONSIBLE TO COMPLETELY SEARCH THESE DRAWINGS, SPECIFICATIONS AND STANDARDS AND FULLY
UNDERSTAND THE REQUIREMENTS NECESSARY TO MANUFACTURE THE ITEM.
9. UNIQUE IDENTIFICATION (UID) SHALL BE APPLIED PER MIL-STD-130:
A. MINIMUM 1/8TH INCH ON HUMAN READABLE TO INCLUDE:
1. CAGE (17V)
2. P/N (1P)
3. SERIAL NUMBER (1S)
B. MINIMUM 1/4 INCH SQUARE ON MACHINE READABLE 2D MATRIX – CONSTRUCT 2 – TO
INCLUDE:
1. CAGE (17V)
2. P/N (1P)
3. SERIAL NUMBER (1S)
C. LABEL SHALL CONTAIN ALL DATA ON EXISTING LABEL, IF EXISTING LABEL IS TO BE
REPLACED.
D. SAME LABEL MATERIAL SHALL BE USED AS SPECIFIED IN DRAWING FOR EXISTING
LABEL.
E. MIL-STD-130, ANSI/AIM BCII, ISO 15434, ISO 15415, AND ISO 15418.
File details come from the government source that posted it. Updated .