PACING_DELIVERY REQUIREMENTS.doc

Aluminum Oxide, size #24 (no substitution allowed)

Unit of issue = 1 ton bag (2000 lbs.)

JML Attachment: For Additional Ordering Requirements

EACH SACK SHALL BE MARKING WITH THE FOLLOWING INFO:

1) STOCK NUMBER: 5350-LL-N03-5951

2) BATCH OR LOT NUMBER (CERTIFICATE OF CONFORMANCE SENT WITH ALL BATCH/LOT RECEIVED SHALL MATCH)

Preparation for Delivery.

The abrasive blasting media shall be shipped in bulk commodity shipping bag with a 5:1 Safety Factor rating, constructed of woven polypropylene; denier not less than 1400 in warp & 1200 in weft; count not less than 16 x14 yards per inch; with double strength sidewalls; single poly top and bottom. Polypropylene is to be treated for ultraviolet light protection to retain 75% strength after 1200 hours in weatherometer. Material must have a bursting test of not less than 450 lbs per inch. Bag will be equipped with a sling with 4 or more pickup points and 4 or more lift straps that cradle the bottom of the bag to provide a method of handling 1-1/2” or wider of reinforced strap is sewn around the top perimeter of container and is included as an integral part of the sling. Sling will be constructed to 2” or wider polyester webbing with break strength of not less than 2000 lbs. Top closure is effected by a nylon tension fastener or plastic coated wire tie. Bottom discharge consists of a 10” diameter concentric spout: 20” lg, closed with nylon tension fastener or plastic coated wire tie. A 3.5 mil polyester liner to be inserted and tied off through bottom of discharge spout, to act as a moisture barrier. Discharge spout when tucked in is covered by a flap barricaded of woven polypropylene; which is then secured with a 1/8” braided polypropylene draw string. Net weight of load must not exceed 2000 lbs. Bags shall be palletized IAW Mil-Std-147 (latest revision); no strapping required. Vendor is to insert a piece of Fiberboard or Plywood between the bag and pallet to prevent the bag from sagging and being punctured by the forklift.