SPMYM2-21-Q-1940 (ORDERING DATA AND SPECIFICATIONS) WELD LEADS.pdf

ORDERING SPECIFICATIONS FOR 4/0 HEAVY DUTY 600 VOLT

WELDING CABLE

DOCUMENT # 1065-3346

• MUST BE APPROVED/CERTIFIED BY A NATIONALY APPROVED TESTING

LABORATORY

• MUST BE # 34 AWG BUNCH STRANDED ROPE LAY COPPER TO REDUCE WIRE

FATIGUE, IMPROVE FLEXABILITY AND INCREASE IMPACT RESISTANCE

• MUST HAVE 100% FABRIC SERVE BETWEEN WIRE AND INSUALTION JACKET

• JACKET MUST BE ON "SUPER-TREX TSE" MATERIAL OR EQUAL AND MUST BE

FLAME/HEAT RESISTANT AND RESISTANT TO SOLVENTS AND CHEMICALS

• COPPER CABLE SHALL NOT TWIST INDEPENDENT OF JACKET CAUSING

"BUNCHING" ON CABLE JACKET BOUNDARY

• AVERAGE JACKE THICKNESS MUST BE 0.158"

• NOMINAL CABLE O.D. 0.900"

• JACKET AND CABLE CONNECTOR COVER MUST BE RED IN COLOR

• MUST BE PRIVATE PERMANENT INK BRANDED "PSNS PROPERTY SHOP 26"

INTERMITTENTLY DOWN LENGTH OF CABLE ALONG WITH DATE OF PRINTING

• CAM-LOC CABLE CONNECTORS MUST BE SOLDERED TO CABLE. MALE/FEMALE

CAMLOC CABLE CONNECTORS SHALL HAVE TAPER NOSE COVERS MOLDED TO

WELD CABLE

• CABLE SHALL BE SUBJECTED TO MECHANICAL, CHEMICAL, ENVIRONMENTAL

AND OPERATIONAL TESTING COMMON TO INDUSTRIAL SHIP BUILDING/REPAIR

ENVIRONMENTS.

• MUST HAVE MINIMUM BEND RADIUS OF 7.2 INCHES

• CABLE JACKET WILL MAINTAIN INTEGRITY WHEN FLEXED AT -20 DEGREE

TEMPERATURES

• MUST BE 4/0 AWG/ 600 VOLT WELDING CABLE

• CABLE SHOULD RESIST CHEMICALS THAT INCLUDE BUT NOT LIMITED TO, SALT

WATER, ACIDS, JET FUEL, PAINT, TURPENTINE, KEROSENE, HYDROCLORIC

CHEMICALS AND GASOLINE