Specifications - PowerLab 4_26 with LabChart Pro.pdf

Specifications

PowerLab 4/26 with LabChart Pro - The PowerLab 4/26 data acquisition system is a 4 channel, 16 bit resolution, recorder with four analog input channels (4 BNC or 4 Pod port DIN connectors), independently selectable input sensitivities, an analog output (non-isolated) for stimulation or pulse generation and a trigger input. The PL2604 features a durable aluminum enclosure as well as a wide range of low-pass filters, AC or DC coupling and adaptive mains filter. The unit features a USB interface for connection to Windows or MacOS computers and a maximum sampling rate of 100 000 samples/s per channel. Includes LabChart Pro software.

AC/DC Differential Amplifier (115V/60Hz, w/ headstage) - The AM3000H is a high gain AC/DC differential (or single ended) amplifier designed for low noise recording from excitable tissue. 115V, 60Hz. Suitable for EEG, ECG and extracellular recording in animals. Input impedance 1015 Ohms//1 pF, Capacity compensation -4 pF to 50 pF and includes headstage for use with high impedance metal electrodes. The headstage supports record, stimulate and impedance modes).

Clamp Mount Micromanipulator (Right) – A standard manual control micromanipulator that features 20 mm of travel in lateral (Y-axis) and vertical (Z-axis) graduated in 0.1 mm increments; 37 mm of travel in probe direction (X-axis) graduated in 0.1 mm increments with fine positioning (10 mm within 0.01 mm increments) and is for use with microscope magnifications up to 250x. All 3 control knobs are located in a single plane for one-handed operation (right hand) and close positioning of several instruments side-by-side. The manipulators with clamp mount are supplied with a 1/2 inch to 10 mm bushing which permits mounting on a magnetic base.

Audio Monitor (115V/60Hz) - This AM3300 Audio Monitor features a built-in 6-band audio equalizer that enables the user to tailor audio performance. 115/60Hz. A quality speaker, a dedicated notch filter, a headphone jack and a line-out (BNC) are included with a universal power supply. Gain: 1V/V, 10V/V, 100V/V, Sensitivity: 0.01 p-p, Input impedance: 20 MOhms, Frequency Range: 22 Hz - 22 kHz, Noise (22 Hz - 22 kHz, 470 Ohm source) 14 V p-p.

Glass Microelectrode Hldr (2mm Pin, N, Port & Wire, 1.5mm) - The Glass Microelectrode Holder (2mm Pin, Narrow, Suction Port & Wire, 1.5 mm) is also known as E.W. Wright Model:

EHW-2MS. It is compatible with any headstage utilizing a standard female 2 mm jack connector.

This holder features a male 2 mm pin, a 99.99% pure silver wire, and is made out of polycarbonate. The diameter of the main body of this holder is 0.25 in. This holder is manufactured to accept a capillary glass with a diameter of 1.5 mm.

Magnetic Base for Clamp Micromanipulator - This is the magnetic base for use with standard clamp micomanipulators. It consists of a main pole (12 x 176 mm, D x L) and sub pole (10 x 164 mm, D x L). It has an 800 N hold force.