SPECIFICATION SHEETS.docx

MULTIPROCESS WELDER SPECIFICATIONS

DOCUMENT # 3070-3340

Must meet the following specifications:

· Multi-process welder must be able to do Air Carbon Arc Cutting and Gouging, (CAC-A), Flux Cored (FCAW), MIG (GMAW), Multi-process Stick (SMAW), Submerged Arc (SAW), and TIG (GTAW).

· Must be able to weld Specialty Metals, Stainless Steel and Steel

· Must have input voltage of 380/400/440 V, 460/480 V

· Must have 3-phase input phase

· Must have input Hz of 50/60 Hz

· Must have input amperage of 53.2

· Must have max open circuit voltage of 87 VDC

· Must have Lift Eye (Standard) and Running Gear / Cart (optional) portability

· Must have CC/CV weld output

· Dimension must be 16.687 inches wide, 28.187 inches high, and 31.625 inches long

· Weight must be no greater than 158 lbs. (for 2 person ergonomic/safe lifting)

· Must have CSA certificate of compliance

· Must be able to use 3/8-inch carbons for cutting and gouging

· Must have Rated Output of 650 A at 44 VDC, 100% duty cycle

· Must have Output Range of 15–815 A, 10–65 V

· Must have All-aluminum construction which helps the machine resist corrosion for long life

· Must have input inductor which protects machine’s performance and reliability from “dirty” input power

· Must have wind tunnel technology; Internal air flow that protects electrical components and PC boards from dirt, dust, debris

· Must have an on demand fan which operates only when needed reducing noise, power consumption, and the amount of airborne contaminants pulled through the machine

· Gouging mode must provide 800 amps of usable power, a full 650 amps of power at 100 percent duty cycle

· Must have digital meters technology which enables welding parameters to be viewed with greater clarity than analog meters.

· Meters must be able to be seen clearly even in direct sunlight

· Meters display must display process settings, preset and actual amperage

· Must have front panel LED process indicator

· Must have standard 14-pin receptacle with auto-remote sense for simple connections of remote controls and wire feeders

· Must have durable weld cable connections, serrated hardware for single-wrench application, easy double weld cable installation and flexible protective covers prevent incidental contact

· Back panel must have 20 amps of 120-volt power to run power tools

· Must have front-panel-mounted power switch for easy access when in racks or manufacturing cells