SALIENT CHARACTERISTICS.pdf

All Electric Hot Pressure Washer Project #221-340

SALIENT CHARACTERISTICS

24 Jul 24

1. All Electric Hot Water Pressure Washer (Qty: 1) (Ben’s Cleaner Sales Inc., Model Mi-T-M DH-

3004-AE0E4G All Electric Hot Water Pressure Washer or equal) shall each include the following requirements:

a. 3.9 GPM @ 3,000 PSI

b. 480 VAC, 3-Phase

c. 100 Amp Draw

d. 8 HP Motor with Manual Overload

e. Mi-T-M 3-0202 Belt Drive Pump

f. Pump is Ran at 60% of capability for Longevity

g. Stainless Steel Pump Module Cabinet

h. Power Coated Heat Exchange Cabinet

i. Patented Stainless Steel Heater Coils in Aluminum Casings for Maximum Efficiency

j. 170 degree to 180 degree Temperature in 3 to 5 minutes

k. Adjustable Thermostats

l. Safety Timer Shut Down

m. Adjustable Pressure Wand

n. Chemical Injector

o. 50 ft Pressure Hose

2. All Electric Hot Water Pressure Washer Option: Remote Box (Qty: 1) (Ben’s Cleaner Sales Inc., Model HX-0298, remote Box Option or equal)

3. Complete and Useable Turn-Key Installation shall include the following:

a. Complete electrical installation (including conduit and wiring) within the steam pad area located in Building 7099, from electrical panel to new pressure washer. All NEC and other electrical codes shall be followed.

b. On-site set-up/start-up and operational testing of the pressure washer

c. On-site Training (Operational, minimal 2 hrs and Maintenance, minimal 1 hr)

NOTE: The government will receive and move into place the pressure washer, connect the water supply and connect the contractor provided pressure washer hose/adjustable pressure wand

4. NRTL Safety Certification Requirements:

a. The equipment and its component parts shall be in compliance with applicable Code of

Federal Regulations (CFR) Title 29, Part 1910. By definition, any equipment will be deemed acceptable and approved by TRF, Bangor, if it meets specific Occupational Safety and Health Administration (OSHA) conditions outlined in CFR Title 29, Part 1910;

Subparts "O" and "S". Specifically, equipment will be "Accepted" by TRF, Bangor, if it has been inspected and found by a Nationally Recognized Testing Laboratory (NRTL) to conform to specified plans or procedures of applicable codes. The equipment (as a whole system) shall be Nationally Recognized Testing Laboratory (NRTL) inspected and certified (by an OSHA authorized third party). One “hard” copy of the NRTL certification report shall be provided. If the equipment type/model has already been NRTL inspected and certified, a certification report (one “hard” copy for the new All Electric Hot Water

All Electric Hot Pressure Washer Project #221-340

SALIENT CHARACTERISTICS

24 Jul 24

Pressure Washer shall be provided) or sticker documentation mounted on the equipment, (which acknowledges it is NRTL certified), shall be provided.