SALIENT CHARACTERISTICS.pdf

Aqua-Dyne Blastmax 50 (or equal) Salient Characteris�cs

1. High Pressure Water Je�ng System (for cleaning Heat Exchanger Tubes)

* Rated for 10K PSI

* Rated for 7 GPM

* Manual Pressure Control Valve

* Rupture Disc for 11K PSI (Relief Valve will suffice if Rupture Disc not feasible)

* Dimensions of the system to be approximately: 48” Tall x 45” Wide x 34” Deep to allow for being portable and allowing system to fit down into the engineering.

spaces of a Naval Vessel.

* Equipped for ½” NPT outlet for Aeroquip quick connects for Hoses along with

Aeroquip quick connects for pressure gauge and relief valve.

* Standard Motor Control Cabinet (MCC) to be installed in lieu of the Variable

Frequency Drive (VFD) and a Fused Knife Disconnect installed on the unit.

* 10 Micron Filter installed on the water side.

* 50 HP Motor, 480V, 3 Phase, 60Hz, 59.2 Am

2. NRTL Cer�fica�on

* The equipment and its component parts shall be in compliance with applicable Code of Federal Regula�ons (CFR) Title 29, Part 1910. By defini�on, any equipment will be deemed acceptable and approved by TRF, Bangor, if it meets specific Occupa�onal Safety and Health Administra�on (OSHA) condi�ons outlined in CFR Title 29, Part 1910; Subparts "O" and "S". Specifically, equipment will be "Accepted" by TRF, Bangor, if it has been inspected and found by a Na�onally Recognized Tes�ng Laboratory (NRTL) to conform to specified plans or procedures of applicable codes. The equipment (as a whole system) shall be Na�onally Recognized Tes�ng Laboratory (NRTL) inspected and cer�fied (by an OSHA authorized third party). Two (2) “hard” copies of the NRTL cer�fica�on report shall be provided. If the equipment type/model has already been NRTL inspected and cer�fied, a cer�fica�on report (two (2) ”hard” copies) or documenta�on mounted on the equipment, (which acknowledges it is NRTL cer�fied), shall be provided.

3. Li�ing and Handling Cer�fica�on

* Li�ing and Handling - The specified equipment shall be equipped with four “maximum load” (including the total weight of the unit, including water, etc.) crane li�ing capable integral (not bolted on) li�ing point items such as lugs, thru-holes, pad-eyes, trunnions and ISO container corner fi�ngs (designed, located, installed and cer�fied per Process Instruc�on (PI) for “Padeyes: Temporary and Permanent;

Installa�on, Use and Removal of” (PI No. 611-400-026B), for Trident Refit Facility, Bangor (TRF, Bangor) ( A copy of this document can be provided upon request), mounted on the top of the unit, correctly spaced for even and level li�ing by a single crane hook (without use of spreader bar). The base of the equipment shall also have con�nuous full-length forkli� slots/tubes (in one direc�on) for handling the unit with a forkli� truck. The forkli� slots/tubes shall be sufficient size (to allow a small to medium forkli� to transport the equipment), and have sufficient separa�on (between the forkli� slots/tubes).

Each unit shall be tested. The Li�ing and Handling Cer�fica�on documenta�on shall be provided (for each unit) prior to delivery of the equipment.