Defensive_Fighting_Position_SoW.pdf

Statement of Work: Defensive Fighting Position

GENERAL: The work to be performed by this contract consists of furnishing all labor, materials, equipment, supplies, and tools necessary to provide a Defensive Fighting Position (DFP) for Joint Base Charleston, South Carolina.

SCOPE OF WORK: The anticipated scope of work for the project include the following:

The Contractor shall furnish satisfactory ballistic certifications from a reputable third party, showing that the material to be used in the actual fabrication of the DFP (same lot of material, not a generic test) must be provided in advance. This applies to the material used in the all walls, doors, shooting ports, windows, and the ceiling. Note: If the lot of material changes in the manufacturing process additional certifications will be required.

The Contractor shall furnish a DFP identical to the DFP on site (drawings attached)

MUST INCLUDE THE FOLLOWING SALIENT CHARACTERISTICS:

Ballistic Resistant Enclosure, ProTech Model #P-506 or equal

8' x 8' x 8' Tall Unit

Ballistic Resistance - .50 APM2 per NPTU Charleston ballistic standard.

To include 360-degree seamless protection, all windows, doors, gun ports, roof, and floor.

Gun ports:

1. Swing Door Gun ports: One (1), Entrance Door

2. Sliding Gun ports (3), on all other gun ports

HVAC - 24,000 BTU Mitsubishi Split System (or Equal)

Electrical, 125AMP panel, 4 duplex receptacles, fluorescent lighting

Anti-skid coated 3/16" steel floor

14 ga. Mild steel interior

Lifted Lugs for installation

High Performance PPG Coating System, Navy-grey Exterior color