STATEMENT_OF_WORK-Engine_OH.pdf

STATEMENT OF WORK

FOR

PRATT & WHITNEY ENGINES OVERHAUL

25 February 2019

1.0 SCOPE

The Original Equipment Manufacturer (OEM) for the Magnetic Minesweeping System MK-105 Mod 4 is EDO Corporation. This Statement of Work (SOW) defines the effort required to support Naval Surface Warfare Center Panama City (NSWC PC) Code A22 to overhaul two Pratt & Whitney ST6L-813 (PT Variant) engines. All work shall be performed by FAA certified personnel and facilities. FAA certified refers to a contractor that has a certificate issued by the FAA under Title 14 of the Code of Federal Regulations (14 CFR) Part 145 and is engaged in the maintenance, inspection, and alteration of aircraft and aircraft products. The scope of the effort includes the task requirements identified in section 3.0.

2.0 APPLICABLE DOCUMENTS

The following documents, of the exact issue shown, form a part of this statement of work (SOW) to the extent specified herein. In the event of conflict between the documents referenced and the contents of this SOW, the SOW shall supersede. Second tier and lower references, (i.e., those referenced in the primary references) shall be used for guidance only.

2.1 Military Standards

None

2.2 Military Specifications

None

2.3 Other Documents

3.0 REQUIREMENTS

3.1 Engine Overhauls

The contractor shall rebuild and return ready for issue (RFI) two each Pratt & Whitney ST6L-813 (PT6 Variant) engines as specified below.

3.1.1 Accessories Overhaul

The contractor shall conduct a complete overhaul of the following engine related accessory line replacement units:

Fuel Control - Fuel Pump Bleed Valve (LH) Bleed Valve (RH)- Oil-Fuel-Heater Flow Divider Fuel Nozzles Overhaul and calibrate two (2) Solenoid Shut Off Valves Calibrate Thermo Bypass Valve P3 Filter Transducer Starter Generator Tach Generator Electro-Hydraulic Actuator Regulator

3.1.2 Restoration Services

The contractor shall make every effort possible to salvage major components in lieu of replacement. The contractor shall rework the following components:

Combustion Section CT Vane Ring (Flow Test) Outer Combustion Liner Inner Combustion Liner

Power Turbine Section PT Housing Assembly PT Stator Exhaust Duct- Standard Restoration

Compressor & AGB Section Gas Generator Case- Recoat with Alseal Compressor Blades - Overhaul & Recoat Compressor Stators & Housing: Recoat Other Plating and Miscellaneous Rework

3.2 Test/Inspection

The contractor shall complete Factory Acceptance Testing for the two engines in accordance with the contractor provided and Government approved test plan. The Government reserves the right to witness Factory Acceptance Testing and requires one (1) week notice before the start of testing. Upon completion of testing the contractor shall document the test/inspection results, findings, and analyses and provide a report that that will enable the Government to evaluate compliance with system requirements, performance objectives, specifications, and test/inspection plans.

3.3 Warranty

The contractor shall provide a warranty for the overhaul engines that warrants that services provided or performed with the skill and care commensurate with recognized standards prevailing in the industry and free from material defects in workmanship as follows:

Overhaul of Engines – the lesser of the applicable manufacturer’s standard operating Time Between Overhaul (“TBO”) or four (4) years from the date of shipment from Company’s facility.

Overhaul of Engine Parts and Accessories – the lesser of 1,000 operating hours or one (1) year from the date of shipment from Company’s facility.

Repairs – the lesser of 1,000 operating hours or one (1) year from the date of shipment from Company’s facility.

4.0 GOVERNMENT FURNISHED PROPERTY (GFP)

4.1 Government Furnished Equipment (GFE)

The Government will provide two (2) each Pratt & Whitney ST6L-813 (PT6 Variant) engines for repair and overhaul. The overhauled engines shall be returned back to the Government at purchase order completion.

4.2 Government Furnished Information (GFI)

The Government will provide the GFI in the form of the manuals to support the pot-maintenance testing of the engine. Additionally, the contractor will be provided access to the logs, manuals, files, and CMPro Access as required throughout the period of performance. All GFI shall be returned to the Government upon completion of the order, unless alternate disposition instructions are provided by NSWC PC.

5.0 DELIVERABLES

5.1 Data Deliveries

All data deliverables shall be submitted in accordance with the attached DD Form 1423.

5.2 Hardware Deliveries

All items listed in SOW paragraph 3.0 shall be delivered to the Government no later than the period of performance end date.

6.0 PERIOD OF PERFORMANCE

The period of performance shall be ninety (90) days after award of purchase order.

7.0 SECURITY

This delivery order is UNCLASSIFIED.

7.1 Release of Information

(a) Release of information shall be in accordance with Section I, DFARS Clause 252.204-7000, Disclosure of Information.

(b) All technical data provided to the contractor by the Government will be protected from public disclosure in accordance with the markings contained thereon. All other information relating to the items to be delivered or services to be performed under this contract may not be disclosed by any means without prior approval of the appropriate NSWC PCD authority. Dissemination or public disclosure includes, but is not limited to, permitting access to such information by foreign nationals or by any other person or entity; publication of technical or scientific papers;

advertising; or any other proposed public release. The contractor shall provide adequate physical protection to such information to preclude access by any person or entity not authorized such access by the Government.

7.2 Controlled Unclassified Information (CUI)

Controlled unclassified information (CUI) is official information that requires the application of controls and protective measures for a variety of reasons and has not been approved for public release, to include technical information, proprietary data, information requiring protection under the Privacy Act of 1974, and Government-developed privileged information involving the award of contracts. CUI is a categorical designation that refers to unclassified information that does not meet the standards for National Security Classification under Executive Order 13526, but is (a) pertinent to the national interest of the United States or to the important interests of entities outside the Federal Government, and (b) under law or policy requires protection from unauthorized disclosure, special handling safeguards, or prescribed limits on exchange or dissemination.

7.3 Minimum Requirements for Access to Controlled Unclassified Information

(CUI)

Prior to access, Contractor personnel requiring access to Department of the Navy (DoN) controlled unclassified information (CUI) or "user level access to DoN or DoD networks and information systems, system security and network defense systems, or to system resources providing visual access and/or ability to input, delete or otherwise manipulate sensitive information without controls to identify and deny sensitive information" contractors must have clearance eligibility, or submit an Electronic Questionnaire for Investigation Processing (SF 86) to NSWC PCD Security for processing and subsequent adjudication by the DoN Central Adjudication Facility.

7.4 Minimum Protection Requirements for Controlled Unclassified Information

Security classification guides and unclassified limited documents (e.g., For Official Use Only (FOUO), Distribution Statement Controlled) are not authorized for public release and, therefore, cannot be posted on a publicly accessible webserver or transmitted over the Internet unless appropriately encrypted.

7.5 For Official use Only (FOUO)

FOUO is a document designation, not a classification. This designation is used by Department of Defense (DoD) and a number of other federal agencies to identify information or material, which although unclassified, disclosure to the public of the information would reasonably be expected to cause a foreseeable harm to an interest protected by one or more provisions of the Freedom of Information Act (FOIA). This includes information that qualifies for protection pursuant to the provisions of the Privacy Act of 1974, as amended. FOUO must be marked, controlled and safeguarded in accordance with DoDM 5200.01, Vol. 4, DoD Information Security Program: Controlled Unclassified Information (CUI), February 24, 2012

7.6 Security of Unclassified DoD Information on Non-DoD Information Systems (DoDI 8582.01) DoD Policy

Adequate security shall be provided for all unclassified DoD information on non-DoD information systems. Appropriate requirements shall be incorporated into all contracts, grants, and other legal agreements with non-DoD entities.

Information Safeguards are applicable to unclassified DoD information in the possession or control of non-DoD entities on non-DoD information systems, to the extent provided by the applicable contract, grant, or other legal agreement with the DoD.

7.6.1 Information Safeguards

Unclassified DoD information that has not been cleared for public release may be disseminated by the Contractor, grantee, or awardee to the extent required to further the contract, grant, or agreement objectives, provided that the information is disseminated within the scope of assigned duties and with a clear expectation that confidentiality will be preserved. Examples include:

a. Non-public information provided to a Contractor (e.g., with a request for proposal).

b. Information developed during the course of a contract, grant, or other legal agreement (e.g., draft documents, reports, or briefings and deliverables).

c. Privileged information contained in transactions (e.g., privileged contract information, program schedules, contract-related event tracking).

It is recognized that adequate security will vary depending on the nature and sensitivity of the information on any given non-DoD information system. However, all unclassified DoD information in the possession or control of non-DoD entities on non-DoD information systems shall minimally be safeguarded as follows:

a Do not process unclassified DoD information on publically available computers (e.g., those available for use by the general public in kiosks or hotel business centers).

b. Protect unclassified DoD information by at least one physical or electronic barrier (e.g., locked container or room, logical authentication or logon procedure) when not under direct individual control of an authorized user.

c. At a minimum, overwrite media that have been used to process unclassified DoD information before external release or disposal.

d. Encrypt all information that has been identified as CUI when it is stored on mobile computing devices such as laptops and personal digital assistants, compact disks, or authorized removable storage media such as thumb drives and compact disks, using the best encryption technology available to the Contractor or teaming partner.

e. Limit transfer of unclassified DoD information to subcontractors or teaming partners with a need to know and obtain a commitment from them to protect the information they receive to at least the same level of protection as that specified in the contract or other written agreement.

f Transmit e-mail, text messages, and similar communications containing unclassified DoD information using technology and processes that provide the best level of privacy available, given facilities, conditions, and environment. Examples of recommended technologies or processes include closed networks, virtual private networks, public key-enabled encryption, and transport layer security.

g. Encrypt organizational wireless connections and use encrypted wireless connections where available when traveling. If encrypted wireless is not available, encrypt document files (e.g., spreadsheet and word processing files), using at least application-provided password protected level encryption.

h. Transmit voice and fax transmissions only when there is a reasonable assurance that access is limited to authorized recipients.

i. Do not post unclassified DoD information to website pages that are publicly available or have access limited only by domain or Internet protocol restriction. Such information may be posted to website pages that control access by user identification and password, user certificates, or other technical means and provide protection via use of transport layer security or other equivalent technologies during transmission. Access control may be provided by the intranet (vice the website itself or the application it hosts).

j. Provide protection against computer network intrusions and data exfiltration, minimally including:

(1) Current and regularly updated malware protection services, e.g., anti-virus, anti-spyware.

(2) Monitoring and control of both inbound and outbound network traffic

(e.g., at the external boundary, sub-networks, individual hosts), including blocking unauthorized ingress, egress, and exfiltration through technologies such as firewalls and router policies, intrusion prevention or detection services, and host-based security services. Prompt application of security-relevant software patches, service packs, and hot fixes.

k. Comply with other current Federal and DoD information protection and reporting requirements for specified categories of information (e.g., medical, proprietary, Critical Program Information (CPI), personally identifiable information, export controlled) as specified in contracts, grants, and other legal agreements.

l. Report loss or unauthorized disclosure of unclassified DoD information in accordance with contract, grant, or other legal agreement requirements and mechanisms.

m. Do not use external IT services (e.g., e-mail, content hosting, database, document processing) unless they provide at least the same level of protection as that specified in the contract or other written agreement.

7.7 Operations Security

Operations Security (OPSEC) is concerned with the protection of critical information:

facts about intentions, capabilities, operations, or activities that are needed by adversaries or competitors to bring about failure or unacceptable consequences of mission accomplishment.

Critical information includes information regarding:

Operations, missions, and exercises, test schedules or locations;

Location/movement of sensitive information, equipment, or facilities;

Force structure and readiness (e.g., recall rosters);

Capabilities, vulnerabilities, limitations, security weaknesses;

Intrusions/attacks of DoD networks or information systems;

Network (and system) user identifications and passwords;

Movements of key personnel or visitors (itineraries, agendas, etc.); and Security classification of equipment, systems, operations, etc.

The Contractor, subcontractors and their personnel shall employ the following countermeasures to mitigate the susceptibility of critical information to exploitation, when applicable:

Practice OPSEC and facilitate OPSEC awareness;

Immediately retrieve documents from printers assessable by the public;

Shred sensitive and Controlled Unclassified Information (CUI) documents when no longer needed;

Protect information from personnel without a need-to-know;

When promulgating information, limit details to that essential for legitimacy;

During testing and evaluation, practice OPSEC methodologies of staging out of sight, desensitization, or speed of execution, whenever possible.

8.0 DISTRIBUTION LIMITATION STATEMENT

Documentation generated under this order shall have the following Distribution Limitation Statement and Destruction Notice affixed to the front cover and title page (if any):

DISTRIBUTION STATEMENT D: DISTRIBUTION AUTHORIZED TO DOD and

U.S. DOD CONTRACTORS (ADMINISTRATIVE OR OPERATIONAL

PURPOSES) (DATE STATEMENT APPLIED). OTHER REQUESTS FOR THIS

DOCUMENT SHALL BE REFERRED TO PEO-LCS (PMS495).

DESTRUCTION NOTICE - FOR CLASSIFIED DOCUMENTS, FOLLOW

PROCEDURES IN DOD 5220.22-M, NATIONAL INDUSTRIAL SECURITY

PROGRAM OPERATING MANUAL, CHAPTER 5, SECTION 7 OR DOD

5200.1-R, INFORMATION SECURITY PROGRAM REGULATION. FOR

UNCLASSIFIED, LIMITED DOCUMENTS, DESTROY BY ANY METHOD THAT

WILL PREVENT DISCLOSURE OF CONTENTS OR RECONSTRUCTION OF

THE DOCUMENT.