SOW.doc

Statement of Work APN7-15 Requirement

BS-650013.APN7METCAL1- LOW FREQ AC/DC CALSTDS

A. Background The use of NAVAIR METCAL equipment funding is to procure Calibration Standards (CALSTDs) and ancillary equipment for Aviation Fleet Intermediate Calibration Activities, Fleet Training Activities and Aviation Navy Calibration Laboratories (NCLs) to support Aviation Organizational and Intermediate (I) level maintenance assets. All Cal Standards listed for procurement must first go through an approval process. This process includes: initial submission by the fleet; review and prioritization by the Fleet TYCOM’s; laboratory workload justification and standardization review by a NAVAIR METCAL technical review team; overall procurement strategy review to assess overall program objectives, priorities and funding.

REQUIREMENTS:

1. Mfr. one year warranty with a warranty certificate.

2. Calibration Certificate and calibration sticker (as applicable for each unit)

3. Units shall be serialized.

4. Include shipping to destination below.

5. Manufacturer’s Standard Operating and servicing manuals (CD version acceptable) shall be provided with each unit. The DFARS clause listed below must be referenced in all contracts and the manufacturer made aware that the use/reproduction of tech data/manuals (for government use only) will follow these use guidelines.

DFARS SUBPART 227.71 - Rights in Technical Data

B. Tasking:

The contractor shall provide the following equipment:

1) P/N 34461A Digital Multimeter Qty 224 To include the following:

a) Digits of resolution: 6 1/2

b) Basic DCV accuracy: 35 ppm

c) Max reading rate: 1,000 rdgs/s

d) Memory: 10,000 rdgs

e) DCV, ACV: 100 mV to 1,000 V

c) DCI: 100 μA to 10 A

d) ACI: 100 μA to 10 A

e) 2- and 4-wire resistance: 100 Ω to 100 MΩ

f) Continuity, diode: Y, 5 V

g) Frequency, period: 3 Hz to 300 kHz

h) Temperature: RTD/PT100, thermistor

i) Capacitance: 1.0 nF to 100.0 μF

j) Statistical graphics: Histogram, bar chart, trend chart

k) Rear input terminals

l) The 34461A Digital Multimeter DC Ratio specification is warranted by the OEM. It is not traceable to ISO 17025, but it is the same warranted specification that currently applies to the 34401A (input accuracy + reference accuracy).

C. Deliverables

Delivery of the equipment shall be provided at the following address:

NAVAIR Calibration Standards MCAS, Attn: Lou Cerrillo

(UIC N48535)BLDG 612, Bay 9

Beaufort, SC 29904-5002

D. Delivery Date

Delivery shall be no later than 6 weeks after award of contract, and shall be absolutely no later than 04-01-2016 E. Cost Estimate

$233,408.00 F. Invoicing

a. All invoicing shall be submitting into Wide Area Workflow for payment after all material is received in the condition as stated in section B.