Performance_Work_Statement_-_DRUCKS_ADTS.docx

Performance-Based Work Statement (PWS)

SERVICE REPAIR OF DRUCK ADTS 410 UNIT(S)

U.S AIR FORCE

524 EMXS/MXDPAE

2/21/2018

SERVICE REPAIR OF DRUCK ADTS 410 UNIT(S)

i

TABLE OF CONTENTS

DESCRIPTION OF SERVICES

This Performance Work Statement (PWS) identifies requirements of the contractor to provide all management, tools, supplies, equipment, materials, and labor required to repair DRUCK Air Data Test Systems (ADTS), model ADTS 401.

BASIC SERVICES

The contractor shall provide major and minor service repair for the DRUCK ADTS 401. The maximum period of performance for any repair is six (6) weeks. The Government will provide the contractor a malfunction report with each unit provided to the contractor for repair. The contractor shall return the units to fully functional operation per the Original Equipment Manufacturers (OEM) specifications and requirements contained in Operators Manual K279 page 5-7 for the Pressure Leak Check and page 5-8 for the Vacuum Leak Check.

REPAIR ESTIMATE

The contractor shall evaluate all DRUCK ADTS 401 units sent to them for repair, categorize the required repair service as major or minor and provide the Government with a cost estimate. The contractor shall not take further action until the repair services and costs are approved by the authorized caller.

MINOR REPAIR SERVICE

The following list of repairs are considered minor: O-rings, washers, seals, gasket or fuses replacement, small leaks and unit not holding pressure.

MAJOR REPAIR SERVICE

The following list of repairs are considered major: All valve replacement, all hardware (casing) replacements, vacuum or pressure pump replacements, front panel replacements, sensor replacements, main PCB board replacements and manifold replacements.

REPAIR SERVICE VERIFICATION

The contractor shall ensure units will at a minimum pass a function test to include: self-test, leak test and calibration check In Accordance With (IAW) the DRUCKS Operators Manual K279 (Pressure Leak Check pages 5-7, Vacuum Leak Check pages 5-8). (CDRL A001)

The finalized calibration certification will be performed by Government Precision Measurement Equipment Laboratory (PMEL).

Units received by the Government that fail self-test, leak test or calibration check will be returned for repair at the contractor’s expense.

SERVICES SUMMARY

GENERAL INFORMATION

SHIPPING INFORMATION

The Government will provide shipping of the units(s) requiring repair to the contract facility, where services will be performed.

Following completion of repairs or the determination by the Government not to complete repairs, the contractor shall ship units to the shipping address below:

524 EMXS/MXDPAE

7274 Wardleigh Rd.

Bldg. 5 Bay C Hill AFB, UT 84056-5137

GOVERNMENT PROPERTY

All Government property provided under this agreement will be provided for repair, maintenance, or overhaul purposes only. The contractor is required to furnish all other property necessary to perform the repair, maintenance, and overhaul services.

The contractor shall be responsible for safeguarding all Government property provided to the contractor.

WARRANTY OF SERVICES

The contractor shall provide a standard commercial warranty on all repaired DRUCK ADTS 401 units.

ENVIRONMENTAL CONTROLS

Compliance with Laws and Regulations. The contractor shall be knowledgeable of and comply with all applicable Interstate, Federal, State and Local laws, regulations and requirements regarding environmental protection. In the event environmental laws or regulations change during the term of this contract, the contractor is required to comply as such law or regulation becomes effective.

APPENDICES

Appendix A – ACRONYMS AND ABBREVIATIONS

Appendix B – EQUIPMENT LIST

image1.jpeg