Wheel_Washer_Tech_Requirements.pdf

Technical Requirements: Aircraft Wheel Washer

Max height 85 inches 41" turntable and 36" work height designated Aircraft Wheel Washer with custom manifold system for removing rubber bead from wheels Swing door with door mounted turntable that automatically retracts when door is opened Turntable Height above Floor: 31.5" Preferred. (30-36" puts it at optimum work height) Heavy 7 gauge 3/16" 304 Stainless Steel Cabinet Thickness 30 kW of electric heat minimum at 460 V 60 Hz.

Oscillating Power Blast Manifold non-synchronous to the turntable at 39 degrees of angle of oscillation with a frequency of oscillation at 4 per minute. Blasts shall be non-intersecting with off-set upper and lower arms.

Wash load will be blasted from a different angle of impingement with each pass by the nozzles.

40 hp Pump System with Viton Seals for use with McGean’s CEEBEE Detergent (If using another system that requires another detergent, said detergent must be listed to be vetted by environmental office on base)

30 hp pump has a total system flow of 274 gpm, with 16.8 gpm flow per nozzle and a system pressure of 168 psi at the PUMP and at blast velocity of 159 ft/sec. This is minimum requirement.

Quick-load Non-scarring Main and Nose Wheel Fixtures designed for specific wheels Heated Fresh Water Rinse System Operating Temperature 160-195 degrees Wash Pump Suction Strainer located in the front of the washer for easy maintenance 16 nozzle minimum, 316 stainless steel 25 degree V jet nozzles 14” Stainless Steel Oil Skimmer Minimum Remote Grease Fitting SS for PBM Swivel Reservoir Capacity must be 180 gallons Minimum Sludge Capacity must be 47 gallons Minimum Programmable Dual Channel 24 hour – 7 day Programmable Clock Electronic Door Safety Interlock Wash Cycle Timer with reset function Automatic Water Level Control & Refill Adjustable Electronic Temperature Control with stainless steel thermocouple Low Water Shut-Off Removable Internal Reservoir Cover Closed Loop Zero Discharge – no wash water or rinse water shall discharge machine Electrical System to meet NFPA 79, includes Safety Power Disconnect, Hour Meter, Turntable Jog, Lifting Lugs, Drain and Clock Override Operating/Maintenance Manual and not cut sheets Professional DVD Training Video 2 Day On Site Training and Commissioning Freight to Military Facility included in total cost (not as a separate line item) No more then 10 minutes, to clean, per wheel

Any "or equal" substitutes must meet minimum requirements or display capabilities in full, to demonstrate that they meet or exceed the requested item.