EDR.pdf

REV: ENGINEERING DATA REQUIREMENTS

(ATTACHMENT “A”)

NOTE: MILITARY SPECIFICATIONS / STANDARDS WILL NOT BE FURNISHED IN THE BID SET.

1. THE FOLLOWING INSTRUCTIONS ARE FURNISHED FOR THE MANUFACTURE OF:

BALLSCREW ASSY, MLG (C-130)

2. PART NUMBER:

8430M4

3. NATIONAL STOCK NUMBER:

1620-01-263-6733

ARED BY:

BRAD LUNDELL

OFFICE SYMBOL:

417 SCMS/GUEA

DATE:

20 NOVEMBER 2013

HILL AFB FORM 462 Page 1 of 1

4. THE FOLLOWING SPECIFICATIONS/STANDARDS, ETC. WILL BE USED IN LIEU OF THE DATA INDICATED. THE

SUPERSEDED DATA WILL NOT BE FURNISHED UNLESS SO INDICATED.

5. OO-ALC LANDING GEAR ENGINEERING RETAINS ALL RIGHTS TO REVIEW AND ACCEPT MATERIAL REVIEW

BOARD (MRB’S) DISPOSITIONS PRIOR TO SHIPMENT OF DISCREPANT ITEM. ALL DEVIATIONS, MINOR AND

MAJOR, FROM THE ENGINEERING DRAWING PACKAGE SHALL BE SUBMITTED FOR MRB DISPOSITION.

6. PRIOR TO CONTRACT AWARD, THE CONTRACTOR SHALL CERTIFY TO THE GOVERNMENT IN WRITING FULL

COMPLIANCE WITH MANUALS, SPECIFICATIONS AND STANDARDS CALLED OUT AND REQUIRED FOR THE

MANUFACTURE OF THIS CONTRACTED LANDING GEAR COMPONENT/ASSEMBLY. CONTRACTOR IS

RESPONSIBLE TO COMPLETELY SEARCH THESE MANUALS, SPECIFICATIONS AND STANDARDS AND FULLY

UNDERSTAND THE REQUIREMENTS NECESSARY TO MANUFACTURE LANDING GEAR COMPONENTS. ANY

QUESTIONS CAN BE FORWARDED TO OO-ALC LANDING GEAR ENGINEERING.

7.1 DRAWING 8430M4: BALLSCREW ASSY, MLG

7.2 UNIQUE IDENTIFICATION (UID) SHALL BE APPLIED TO EACH PART PER MIL-STD-130. THE UID SHALL

CONTAIN HUMAN-READABLE INFORMATION (HRI) AND MACHINE-READABLE INFORMATION (MRI)

MARKINGS. QUALITY AND TECHNICAL REQUIREMENTS FOR BOTH THE MRI AND HRI SHALL BE IN

ACCORDANCE WITH SAE AS9132. THE METHOD OF MARKING FOR THE HRI SHALL BE LIMITED TO ELECTRO-

CHEMICAL ETCHING, DOT PEEN, VIBRO PEEN, OR MICRO-MILL. THE DEPTH OF EACH MARK SHALL BE FROM

.003 - .005 INCHES. THE HRI MARK THE HRI SHALL INCLUDE BOTH THE PART NUMBER AND THE SERIAL

NUMBER. THE SERIAL NUMBER WILL BE LIMITED TO 16 ALPHANUMERIC CHARACTERS INCLUDING THE

VENDOR CAGE (FSCM) OF THE CONTRACTOR NAMED ON THE CONTRACT, DATE OF MANUFACTURE IN THE

FORMAT MMYY, AND A UNIQUE 4-DIGIT NUMBER STARTING WITH 0001 IN NUMERICAL ORDER OF

MANUFACTURE. THE HRI SHALL APPEAR AS “SN 9874701040001”. THE HEIGHT OF EACH ALPHANUMERIC

CHARACTER IN THE HRI SHALL BE A MAXIMUM OF .125 INCHES. THE METHOD OF MARKING FOR THE MRI

SHALL IN ACCORDANCE WITH DRAWING 200827953-01, -03, OR -15. APPLY TWO TOPCOATS POLYURETHANE

OVER LABEL PER MIL-PRF-85285, TYPE I, CLEAR PER FED-STD-595. TESATAPE LABEL SHALL ONLY BE PLACED

ON THE TOP COAT OF THE PAINTED COMPONENTS.