EDR.pdf

PAGE OF1 PAGES1

Circuit Card Assembly

2218155-001 5998-01-599-6250

Deviations from specifications identified in drawings are not authorized without prior approval by 416 SCMS/GUMAA Engineering.

Part Marking as per MIL-STD-130 in lieu of FPS-3008

IUID (Item Unique Identifier) requirements and expectations which the contractor must ensure are complied with.

a. Contractors drawings shall be changed or supplemented by contractor for IUID compliance.

b.. Label shall contain all data on existing label, (if existing label is to be replaced), only delete existing label with government engineering permission.

c. Use HRI (Human Readable) and Machine Readable Matrix. (USAF not equiped to read barcode).

d. IUID Matrix needs to be highly visible, in a location easily accessible.

e. IUID marking must be permanent.

f. MIL-STD-130, ISO 15434, ISO 15415, and ISO 15418

i. IUID marking specifications.

1. Minimum 1/8 inch lettering on Human readable to include:

a. Cage (17V)

b. P/N (1P)

c. Serial Number (IS)

2. Minimum 1/4 inch square on Machine Readable 2D Matrix -construct 2 - to include

a. Cage (17V)

b. P/N (1P)

c. Serial Number (IS)

If deviations from these instructions are required or desired, permission from government engineer is required.

Curtis Blanco, Electronics Engineer 416 SCMS/GUMAA 20120822

REV:

ENGINEERING DATA REQUIREMENTS

(ATTACHMENT "A")

NOTE: MILITARY SPECIFICATIONS I/STANDARDS WILL NOT BE FURNISHED IN THE BID SET.

1. THE FOLLOWING INSTRUCTIONS ARE FURNISHED FOR THE MANUFACTURE OF

2. PART NUMBER 3. NATIONAL STOCK NUMBER

4. THE FOLLOWING SPECIFICATIONS/STANDARDS, ETC., WILL BE USED IN LIEU OF THE DATA INDICATED. THE SUPERSEDED DATA WILL NOT BE

FURNISHED UNLESS SO INDICATED.

PREPARED BY SYMBOL DATE

HILL AFB IMT 462, 20060123, V1 REPLACES HILL AFB IMT 462, 19961001, WHICH IS OBSOLETE.