B8 - Purchase Description Enclosed Cargo Trailer.pdf

W912NS21Q3515 – Enclosed Cargo Trailers

Fully Enclosed, Dual Axle Utility Trailer – Quantity 4 EA

The following salient characteristics must be met or exceeded

1. Brand new, not refurbished, re-purposed, or rebuilt.

2. All the following requirements must be installed by the manufacture or authorized representative of the manufacturer as to not detract from the functionality or aesthetics of the trailer.

3. Basic white color scheme either prefinished aluminum skin or covered with an exterior rated coating

4. Constructed with a MINIMUM of .030 aluminum skin, fastened with screws.

5. “V” Nose.

6. A MINIMUM of (not including the tongue) of 20 Feet long and NO MORE THAN 22 feet long cargo box length. Inside width dimensions of approx.. 83”

7. Weather proof, and be sealed to prevent water intrusion.

8. Inside walls will be plywood with interior bracing capable of supporting d rings mounted in item 25. White walls coated to allow for maximum reflection of interior light.

9. A ground clearance of at LEAST 10 inches.

10. An aluminum frame.

11. A payload capacity of at least 10,500 pounds.

12. Equipped with a 2 and 5/16 inch adjustable coupler.

13. Equipped with a minimum of a 12,000 pound spring return jack.

14. Wall Frame and floor cross members located no further apart than 12 inches.

15. Fully enclosed, with a MINIMUM internal height of 7 foot, 6 inches measured at the walls.

16. Wheels and tires on the OUTSIDE of cargo bed, no inside fender-wells.

17. Dual axle, with torsion equal to or greater than the payload capacity, oil bath axles with self-adjusting electrical brake system.

18. Stainless Steel DOT approved fenders.

19. supplied with a minimum of 16 inch “E” range 10 ply tires (235/80R16), mounted on aluminum wheels

20. a spare tire with the same installed rims and tire assembly as installed on the main axles outfitted with an inside, built-in mount, for a standard sized spare tire, mounted above the winch centered on the front inside wall of trailer interior

21. walk-through side door on the passenger Side, a minimum of 32 inches wide with two externally keyed locking deadbolts on the upper and lower corner of the side entry door.

22. Extruded aluminum plank flooring.

23. Flat deck, NO DOVETAIL.

24. 6000 pound D-Rings mounted in the floor in 4 columns left and right. Inside columns

1 foot off center and left and right outside columns 2 inches off the wall. On floor from front to rear 6 D-rings evenly spaced.

25. A minimum of 6 D-Ring tie downs on each wall with a minimum of 6000 pound

W912NS21Q3515 – Enclosed Cargo Trailers mounted two rows of 6 D-rings from front to rear to match floor D-ring spacing. One row at 18 inches and one row at 36 inches off of floor. Less on door opening side is acceptable.

26. LED lighting for all DOT required lighting with LED dome lighting capable of fully illuminating trailer interior.

27. All DOT required fenders, lighting, markings, reflective devices, and safety equipment installed.

28. A single rear drop down weatherproof door that doubles as a loading ramp capable of supporting 5,000 pounds. Latch that fits a standard padlock in order to lock the door lever in place on the inside of the ramp door so it would not be possible to open the door from outside the trailer.

29. Gap cover on the transition from ramp to decking and ramp to ground.

30. Have a MINIMUM of a 5000 pound, remote controlled, electric winch with at least 75 feet of cable sufficiently sized for the winch system. Center mounted in the nose in the V section of the trailer.

31. A metal box built around the winch for load protection.

32. A single 12 volt maintenance free battery mounted in a battery box vented to the outside of the cargo box. Battery will be sufficient to power winch system for a minimum of 20 minutes under a load.

33. Wired for a Dual Purpose Solar Powered/Tow vehicle powered battery charging system. Provided Solar charger should be strong enough to trickle charge supplied battery to keep it from draining while not in use.

34. A minimum of a two year bumper to bumper warranty.

35. Supplied with full maintenance and parts manuals at delivery. Electronic format is acceptable.