A06_Specifications.pdf

Indiana Dunes National Park

Project Specifications

Three Panel Inline Kiosk with Roof

PURPOSE: Manufacture 15 three panel inline kiosks with roofs for parking lot locations in the park.

Indiana Dunes National Park is a very complex park with many entrances and access points. The 15 panel sets will be placed in the parking lots to provide visitors with a sense of arrival. The three panels will contain important wayfinding, programming, and safety information. The left panel will hold the park orientation map, the right panel will hold the trail map to the specific location, and the middle panel will be a bulletin board case with information that will change monthly. The middle panel (bulletin board case) will need to open, close, and lock, while the left and right panels will not. The left and right panels must have an access point to slide printed substrate into a groove (see photo examples). The groove will hold the 36”w x 48”h substrate into a viewable area much like a frame.

The panels will be installed in harsh sunlit all‐season outdoor conditions which causes the panel graphic to fade. The panels will contain roofs to protect the panel maps and bulletin with shade so that the graphics will not need to be replaced as often.

SCOPE: The contractor shall furnish 15 three panel roofed kiosks. The panel should be built in aluminum to withstand the has all season weather conditions. Each panel will have the ability to change graphic panels and a locking bulletin case. The kiosks should maintain the look and standards set by National

Park System and Harpers Ferry design guidance. Park staff will install the kiosks. The kiosk will be directly embedded into the ground and held in place by cement.

SPECIFICATIONS:

Constructed in aluminum and painted with NPS Brown

All three panels must connect and be inline with one 3/16” flat aluminum roof that covers all three panels with adequate shade to protect the graphic panels (approx. 136” wide x 34”)

All three panels will house 36” x 48” graphic panels

Bottom of graphic panels should be 32” above the ground

Aluminum roof should have rounded smooth edges for visitor safety

Have long enough legs to be directly embedded into ground while maintain readable height. Structure support legs should be 140”, (30” should be buried 32” from ground to bottom of graphic panel, 48” along graphic panel, and 30” to roof.)

Panels must hold 36” width x 48” height x 3/8” depth printed substrate

Lowest point of the roof must be high enough to avoid causing injury to visitors with rounded corners

Roof must extend enough to provide sun protection to graphic panels

Bulletin Board Case

Must have locks

Access door with nonfading scratch resistant plexiglass

Have a magnetic backing to support graphic information to be set in place with magnets

Case should be the same size as the panels 36”x 48” with a viewable area no less than 30 ¾” x

43”.

Have weep holes with insect screens on the bottom

DELIVERY LOCATION:

Indiana Dune National Park

1100 N. Mineral Springs Rd, Porter IN 46304

DELIVERY SCHEDULE:

Arrangements for delivery must be made with Delivery POC 1 (one) week prior to shipment.

Complete delivery within 240 days after award

FOB to delivery address.

Kiosk Examples

Panel grooves for graphics substrate.