Recommended_Confirguration.doc

POC: CW3 Hord or Mr. Pyle at (910) 396-1814 E Co 1st Bn, 1st SWTG(A)

Trailer Options

1. 8.5' x 22' Tandem V-nose trailer, chrome front nose, ATP front corners, exterior metal, one piece aluminum roof, 24" stone guard, bullet LED clearance lights, LED taillights, Dexter 3.5k EZ lube torsion axles with brakes, radial tires load range D, powered coated trailer wheels, 16" on center floor crossmembers, 16" on center wall studs and roof bows.

2. ¾" Treated Plywood floor with Rubber Coin Protective Floor Covering. Tie downs in floor of storage area to secure boxes for transportation.

3. Spring assist Ramp Rear Door: Rear Ramp Door with spring assist, Cam Lock and Rear Corner post Jacks.

4. Ramp Extension: Flip down Diamond Tread Plate Gap Filler for Ramp Door.

5. Ceiling Liners: Curved to Roof Contour; ¼" White Vinyl Plywood Ceiling Liner & Insulation.

6. Wall Liners: ¼" White Vinyl Covered Plywood.

7. Insulation: 1" Ceiling Insulation, R-5 Value. 1" Fiberglass Sidewall Insulation, R-5 Value.

8. ATP Stone Guard & Anodized Corners 48" High ATP wrapped corners.

9. 36" x 78" RV Side Door with Steel Strap Hinge & FlushLock, aluminum treshhold cover.

10. Two Tinted windows on opposite side concession window, one over counter and one towards the front of trailer?

11. Concession sliding type Window on awning side of trailer. Size; H" 30 x W 26"

12. LED interior light Fixtures: 6' Long.

13. Exterior side flush mounted LED flood lights; 2 per side, 1 on front and 1 on rear of trailer spaced evenly between the front and rear of trailer.

14. Exterior Duplex GFI 120 Volt Flush Mounted (20 AMP) Receptacles: (4 each) two on each side of trailer, one to the rear each side and one towards the front on each side.

15. 3 Way wall switch for 120 Volt Lights.

16. 18' roll out Awning on each side with poly or metal storage cover.

17. Awning Support: Sliding Awning Rods

18. Stabilizers: Two (2) adjustable corner posts stabilizers on the front corners, rear corners and two centrally located on the trailer. Removable front and rear corner post (scissor type – 5000 lb.).

19. 12" extended tongue with 12 volt electric jack – 3000 lb.

20. Tires and Wheels: 75R / 15" radials

21. Spare tire carrier (interior). Mount the spare tire somewhere else (possibly inside trailer storage over the tongue with the generator.)

22. Honda EU7000IS quiet inverter and Generator mounted in trailer tongue storage area, removable when needed for use.

23. Air Conditioner: Low profile Roof Mount 120V, 13,500 or 15,000 BTU with Heat Strip.

24. Roof Vents with powered Exhaust Fans (2) each centered on either side of the roof mounted Air Conditioner unit and the front and rear of the trailer; total of (6).Deluxe Electrical Package with additional outlets. (3 per wall under desk and two 6' outlet strips mounted on the wall in rear storage areas for Battery Chargers)

25. A panel which can be outfitted with barrel connectors, female to female, for a sealed area to get wiring from the storage area to the inside of the work-space. This can be accomplished with a small trap type door located in the floor of the storage area out of the way in close proximity to the panel to run antenna coax wire to the outside

26. Laminated Permanent inside counter that will accommodate four (4) workstations. (need electrical outlets for this area as described in 1.)

27. 22" deep x 32" height wrap around work station Desk with 2 Drawer File Cabinets on front wall workstations. (2 each). (Need electrical receptacles under each desk on wall for computers).

28. Mounting area on front wall, right side for 32" flat panel TV.

29. Steel Cabinet with Four Pull-Out Locking Drawers.

30. Workbench and Cabinet with four drawers, counter space and overhead shelves designed for approximately 4' Width of Interior side walls for mounting radio charging stations and storage of equipment.

31. Install a divider curtain (tinted or net) to divide workspace from storage briefing area and freezer curtain at rear ramp.

· Changes or additions may have to be made to this design after exact costs and also for practicality of use by our cadre.

· This is only an illustration with ideas on how we see the trailer package. This in no way is to be considered as a laid in stone blueprint of the completed trailer. Any questions or recommendations on this please feel free to ask?

Small Trap doors for radio/antenna coax cable to the outside antennas

TV

Shelves

36"

22"

Rear Door

Steel Cabinet large Pull-out Locking Drawers, laminated counter space and overhead cabinets.

Fridge Space

Steel Cabinet large Pull-out Locking Drawers, laminated counter space and overhead cabinets.

Storage door in the V-front walled from the work stations

Windows

Laminated Desk

Side Door

Sliding Window Door Under Awning