13343342-SALIENT CHARACTERISTICS.pdf

800 AMP MAXIMUM CAPACITY ½” DIAMETER INVERTER STUD WELDER ORDERING SPECIFICATIONS

DOCUMENT # 1334-3342

1. MUST BE ABLE TO DELIVER UP TO 800 AMPS AND SHOOT UP TO ½” DIAMETER FULL BASE DIAMETER

STUD.

2. MUST MONITOR INPROCESS SIGNALS TO DETECT BAD WELDS

3. MUST MONITOR AND ADAPT GUN SPEED TO ALLOW FOR GUN WEAR

4. MUST MONITOR CABLE AND CABLE CONNECTORS TO DETECT CABLE WEAR AND LOOSE CONNECTORS

5. MUST HAVE PRE PROGRAMED STUD DIAMETER SETTINGS AND MUST BE ABLE TO BE REPROGRAMED

FOR CUSTOM STUD SHOOTING

6. MUST HAVE PULSE WAVE FORM THAT REDUCES HEAT INPUT, CUTS SURFACE CONTAMINANTS AND

STIFFENS ARC FOR OUT OF POSITION WELD

7. MUST HAVE PLUNGE CURRENT FEATURE (OR EQUAL) TO SAVE ELECTRICITY, REDUCE CABLE WEAR, AND MAINTAIN ARC ENERGY DESPITE GUN WEAR

8. MUST BE CAPABLE OF EXTENDING ARC TIME WHEN STUD PLUNGE IS SLOWED DOWN

9. MUST BE ABLE TO RECORD WELD QUALITY AND HAVE ARC SIGNALS OSCILLOSCOPE PC SOFTWARE

10. MUST BE AN INVERTER

11. MUST HAVE INTEGRATED GAS CONTROL OPTION FOR PROGRAMABLE PRE AND POST FLOW FOR

ALUMINUM AND GALVANIZED STUD WELDING

12. MUST BE APPROVED AN OSHA RECOGNIZED NATIONALLY APPROVED TESTING LABORATORY

13. MUST HAVE A 2 YEAR OR 1,000,000 WELD WARRANTY

14. MUST HAVE CURRENT RANGE OF 50A-800A AND BE CONTINIOUSLY ADJUSTABLE

15. MUST HAVE WELD TIME RANGE OF 5-100 MS

16. MUST HAVE WELD RATE OF 3 EA. ½” STUDS PER MINUTE, 6 EA. 3/8” STUDS PER MINUTE, AND 12 EA.

¼” STUDS PER MINUTE.

17. POWER SUPPLY MUST WEIGH 40 LBS. OR LESS

18. MUST USE 3 PHASE 400-460V, 50/60 Hz @ 15 AMPS

19. MUST BE CAPABLE OF USING NELSON NS-40 LIGHT DUTY PINNING GUN OR EQUAL

20. MUST HAVE DINSE POWER CONNECTORS

21. MUST INTERFACE WITH S/26 CURRENT INVENTORY OF 800 AMP STUD WELDING SYSTEMS.

22. MUST BE ABLE TO BE TAKEN SHIPBOARD THROUGH EXISTING ENTRY DOORS AND HATCHES