1. Statement of Work.pdf

STATEMENT OF WORK

DESCRIPTION/WORK STATEMENT/SPECIFICATION

FOR

WORK PLATFORM

1.0 PURPOSE:

This specification establishes a requirement for the design and delivery for three (3) Work Platform

Packages which will be used in Anniston Army Depot’s vehicle assembly and disassembly facility building 400 to provide access to elevated areas of vehicles during the disassembly and assembly process.

2.1 .REQUIREMENT:

3.1 Compliance: The manufacture and/or designer of the Work Platform shall design and manufacture a walking working surface compliant with Occupational Safety and Health Administration (OSHA) 1910

Subpart D. Any and all stability or cantilever modules shall be in compliance with American National

Standard for Manually Propelled Elevating Aerial Platforms (ANSI/SAIA) A92.3-2006 (R2-14)

4.8.1/4.8.2.

3.2 Capacity: The working load rating per platform section shall be a minimum of 1000lbs.

3.3 Dimensions: The Work Platform shall be designed to fit half around one end of the M1 Abrams military tracked vehicle. The inside opening of the Work Platform should be 146 inches. The walking working surfaces shall be 36 inches wide. The overall length of the two walking work platform surfaces along the sides of the vehicle shall be 146 inches with pivotal stair case at the end of each side platform.

The overall length of the one walking work platform across the back or front of the vehicle shall be 146 inches.

3.4 Elevation: The walking working surface shall be capable of traveling from an elevation of 24 inches to 72 inches by means of a hand crank. The force required to rotate the hand crank through the 24-72 inch range of motion shall not exceed 45lbs. The platform shall be stable and support 1000lbs per platform at any elevation within the identified range.

3.5 Stairs: The stair treads shall remain parallel to the walking working surface regardless of the elevation. The stairs with handrails shall travel with the walking work surface without an additional hand crank.

3.6 Mobility: The Work Platform shall be capable of separating into three (3) sections that can be rolled around by hand on 8 inch premium dual disc swivel casters. Once in position around the vehicle, the

Work Platform sections shall be capable of connecting to each other, and the casters must have swivel locks and brake functions.

3.7 Material: The construction shall consist to the highest extent possible of aluminum materials so that the overall weight is minimized. The heaviest platform section should not exceed 1200lbs.

3.8 Design: A dimensional design drawing shall be submitted for approval prior to fabrication. OSHA compliant handrails are required.

3.9 Miscellaneous: All handrails shall be powder coated safety yellow. All mounting hardware shall be included.

3.10 Supporting Information: This scope of work shall be limited to one (1) Work Platform

Package. The design, fabrication, and delivery shall not to exceed a delivery time of 120 days.

3.11 Supporting Documentation: The vendor shall supply four (4) printed and one (1) electronic copies of maintenance and operational manuals.

3.12 Equivalent Substitutions: In the case of substitutions for equal parts/components the contractor shall provide documentation and demonstration showing that component(s) meet or exceed performance specification and parts interchange ability of specified welding equipment and/or component parts.

4.0 WARRANTY:

The Work Platform Package shall carry a one (1) year warranty on parts and labor covered by the vendor beginning after acceptance at Anniston Army Depot.

5.0 DELIVERY AND POINTS OF CONTACT (POC)

Delivery is expected within 120 days of contract award. The Work Platform Package shall be delivered to building 400.

6.0 SCOPE CHANGES

The Contractor shall not proceed with any verbal or written change(s) to the scope of work from sources other than the Contracting Officer, who will provide changes in writing.